Electronics Forum | Fri Feb 04 09:17:30 EST 2005 | Steve Gregory
I have a need for two heater element/strips for the pot of a Econopak EPK+ Type 400F. PN 3-0606-793-01-2. I was told it would be 2-3 weeks from Electrovert. If anybody knows of where I might get them quicker than 2-3 weeks, I sure would appreciate it
Electronics Forum | Fri Jun 23 12:21:29 EDT 2017 | rgduval
I'm going to guess that you've tried Speedline with no success. They're awfully annoying about their older machines. Things to check: - Thermistor for the zone working properly? - Opto for the zone working correctly? - Heaters working correctly? -
Electronics Forum | Thu Feb 13 14:20:19 EST 2014 | globalpowerproducts
we set the pre heaters the same as the Electrovert. On the SHEO wave solder it is a much longer conveyor so we only turned on the last two pre heaters to match the Electrovert
Electronics Forum | Tue May 18 03:23:56 EDT 1999 | PhilB
Looking at the full convection reflow oven market, I see two segments, high mass heater ovens (i.e. Electrovert Omniflow,...), and low mass heater ovens (i.e. Heller,...) Did some of you guys did some testing on both types and what were your findings
Electronics Forum | Wed Jul 10 22:13:45 EDT 2019 | SMTA-Ray
I don't recall if the heater wattage is the same or not for the different pots. If the wattage is different then the PID algorithm is also different. this anticipated when & by how much the heater will overshoot its setpoint and turns the heater off
Electronics Forum | Tue May 16 15:16:26 EDT 2006 | Chunks
Not knowing your brand of Heller, I might suggest disconnecting the first cooling section to verify it's your heater fans. I just had a retro kit done to my Electrovert for a similar thing.
Electronics Forum | Tue May 18 18:17:50 EDT 1999 | Scott Cook
| Looking at the full convection reflow oven market, I see two segments, high mass heater ovens (i.e. Electrovert Omniflow,...), and low mass heater ovens (i.e. Heller,...) | Did some of you guys did some testing on both types and what were your find
Electronics Forum | Tue May 18 14:47:02 EDT 1999 | Dave F
| Looking at the full convection reflow oven market, I see two segments, high mass heater ovens (i.e. Electrovert Omniflow,...), and low mass heater ovens (i.e. Heller,...) | Did some of you guys did some testing on both types and what were your find
Electronics Forum | Sat Jan 14 18:07:15 EST 2006 | Sona
I am looking for someone on the East Cost to service the following equipment. Electrovert EPK and DEK 260. We need to also add some convection heaters on the wave machine. We are located outside Philly, Pa If anyone can provide me with this info I a
Electronics Forum | Mon Oct 14 15:48:37 EDT 2002 | pjc
If you are concerned with the actual temp of your pre-heater verses what the machine's display "says" the temp is, use a calibrated digital thermometer and place the thermocouple probe inside the pre-heater and next to the machine's thermocouple for
