Electronics Forum | Tue Jun 25 15:30:49 EDT 2002 | Steve L
Hi everyone. I am now faced with a problem on soldering PBGA. At first, I ran the board (FR4, 7" X 10" with 12 layer) at Peak Temp: 205 C and 54 seconds above 183 C. After reflow, I found several cold solder joints and one ball without second collaps
Electronics Forum | Fri Apr 29 14:16:16 EDT 2011 | ppcbs
Below is the long explanation. This defect is most commonly found with BGA components, but can arrise with all components. I see it happening more now with lead free boards that are being assembled with a no clean flux. Best short term remedy is t
Electronics Forum | Mon Jun 23 04:00:43 EDT 2003 | Paul Cooper
Hi there There are a number of things worth considering when viewing bga's. Firstly, like any other solder joint that you have been inspecting for years, suface finish is critical. Secondly, and again like other joints shape is important. Now it may
Electronics Forum | Wed Feb 03 23:40:26 EST 1999 | Chris G.
| Does anyone know if I will have problems soldering surface mount components to an all hard gold plated PC board. We want to use hard gold similar to gold used for edge fingers because our customer is concerned about wear and conductivity of connect
Electronics Forum | Thu Jul 28 05:41:22 EDT 2005 | K
Hi guys, Have any of you encountered harwin connector M80-647 in the past? Have you noticed any problems with the reliability of the component, solderability and 'reworkability' (thats a new word for sure)? Heres a PDF of the component; http://www.
Electronics Forum | Thu Jun 03 10:09:59 EDT 1999 | Earl Moon
| In a month or so, we will be getting an in-line x-ray inspection machine. It will require that we solder our most comlicated side (normally top) first. This is opposite to our process now where we solder our passive (bottom) side first. We cann
Electronics Forum | Thu Jun 03 10:53:09 EDT 1999 | Ryan Jennens
| | In a month or so, we will be getting an in-line x-ray inspection machine. It will require that we solder our most comlicated side (normally top) first. This is opposite to our process now where we solder our passive (bottom) side first. We ca
Electronics Forum | Thu Jun 03 12:31:30 EDT 1999 | Dave F
| | | In a month or so, we will be getting an in-line x-ray inspection machine. It will require that we solder our most comlicated side (normally top) first. This is opposite to our process now where we solder our passive (bottom) side first. We
Electronics Forum | Thu Jun 03 13:00:16 EDT 1999 | Earl Moon
| | | In a month or so, we will be getting an in-line x-ray inspection machine. It will require that we solder our most comlicated side (normally top) first. This is opposite to our process now where we solder our passive (bottom) side first. We
Electronics Forum | Thu Jun 03 14:06:16 EDT 1999 | Dave F
| | In a month or so, we will be getting an in-line x-ray inspection machine. It will require that we solder our most comlicated side (normally top) first. This is opposite to our process now where we solder our passive (bottom) side first. We ca