Electronics Forum | Tue Feb 08 03:55:18 EST 2005 | Rob.
We got ours hooked on solderballs - 2 birds with one stone!
Electronics Forum | Thu Mar 08 06:30:48 EST 2007 | tommyttr
Chris, The machine is looking for a response from the LC. Usually, it will hang up from a corrupted .gf file. delete all the .gf files from the station. make sure you are NOT hooked up to the LC and/or LC turned off, put machine in stand alone mode.
Electronics Forum | Mon May 07 15:54:22 EDT 2007 | joeherz
If you're looking for something for less than $5-10k, you should consider setting up a point-of-use air drying system. If you can supply fairly dry air from a house system to the point of use dryer, you can acheive humidty levels below 2% easily. W
Electronics Forum | Wed Mar 12 23:00:10 EDT 2008 | davef
You can say: The pad was lifted after reflow and prior to the dye and pry failure analysis. When we see lifted pads, we think: * That's a good solder connection * Either it took a lot of force to lift that pad or the fabrication of the board in the
Electronics Forum | Sat Feb 16 22:19:11 EST 2013 | mdang
Hi, I bought a fuji Flexa v4.6.0.7 and hook it hook it up with CP65 machine. The flexa system already have CP65 configure so I can see the production program on the machine and delete them but I can not transmit a new program to the machine. It error
Electronics Forum | Wed Mar 14 08:45:41 EST 2001 | stefwitt
In order to track the board flow through your line you will have to hook up all conveyor input sensors as well as the last output sensor to a PLC. You can program the PLC to provide an alarm signal if a accumulative time of xxx hours for any board is
Electronics Forum | Wed Jan 22 15:22:53 EST 2003 | davef
Hey "Dispenser Boy" does this mean we can have your machine? ;P I'll be out to supervise the packing with a Hook in my hand. Poke around the fine SMTnet Archives to get started on aperture design. 7525, Stencil Design Guidelines is pretty much of
Electronics Forum | Thu Jan 23 09:17:08 EST 2003 | bdoyle
There's a Red Hook brewery about 40 minutes south of here. I've taken that tour a few times. Don't let Dave fool you though, he's changing tastes and is beginning to import beer from Maine.
Electronics Forum | Tue Sep 09 06:57:52 EDT 2003 | cyber_wolf
Yes I have cleaned the nitrogen knives out, and I have a chiller hooked to the heat exchanger(radiator).I am starting to think that I need to replace the radiator with another blower...??? Thanks for the input. Regards, Sr.
Electronics Forum | Fri Nov 19 13:00:06 EST 2004 | russ
Hook it up to a server and only allow read access to the operators for the files. Then if changes have to be made it will take the appropriate person to overwrite the file and save it to the server drive. Russ
