Electronics Forum | Tue Sep 13 07:00:28 EDT 2016 | awhite
Thanks for the reply. When you hit start on the printer, you can see it send the "start cycle (SMEMA)" signal, and it immediately goes to "awaiting board from upstream." This tells me that the printer knows a signal has definitely been sent and rece
Electronics Forum | Mon Apr 30 18:17:16 EDT 2001 | ianlg
Hi Barry Unable to assist on specifics but I can tell you that some 74 100is machines were built. The majority residing in China Imported in by Wong King Kong Ltd ( Johnson lee Tel 00852 2357 8888 ) Most are at either Flextronics or Roslare. You mi
Electronics Forum | Tue Oct 13 08:09:53 EDT 2009 | kudamarani08
Can anyone help me recommend or simulate a SPI and AOI machine that can balance our FUJI NXT 1 with 14 modules. We are using MPM accela printer. 200 UPH is our target. Here's the PCB dimension length(x) = 399.92mm width(y) = 141.626mm Thanks all!
Electronics Forum | Wed Sep 14 02:41:49 EDT 2016 | bukas
here is well explained SMEMA interface http://www.daghee.com/?p=326 so, disconnect printer from upline modules and check are any 2 of 4 pins shortened(should be pins No 1 & 2) while machine is ready state. when machine is in busy state the same pin
Electronics Forum | Tue Oct 13 22:56:22 EDT 2009 | cpcompany
Can anyone help me recommend or simulate a SPI > and AOI machine that can balance our FUJI NXT 1 > with 14 modules. We are using MPM accela printer. > 200 UPH is our target. > > Here's the PCB > dimension > > length(x) = 399.92mm width(y) = >
Electronics Forum | Tue Sep 20 15:00:26 EDT 2016 | awhite
Got it!!!!! On the main Operator Screen for the MPM UP2000, and under configuration (when logged-in under maintenance), it gives you ONLY the settings that the machine is set to....there are no drop-downs or options available to choose from. Very fr
Electronics Forum | Mon Feb 12 12:51:19 EST 2018 | dleeper
Yes, the vision system in the MPM accuflex, as well as on other MPM printers is reversed. It's kind of weird but you get used to it.
Electronics Forum | Mon Dec 20 19:59:27 EST 1999 | se
Printer and Pick/Place manufacturers will often take used equipment in trade from potential customers that want to buy new, if they know they can sell it. Inquire to the manufacturers for used or refurbished models they sell and support. If you buy a
Electronics Forum | Fri May 15 14:50:40 EDT 2015 | emeto
My top 3 printers: 1.DEK 2.MPM 3.EKRA Top 3 ovens: 1. BTU 2. Vitronics 3. Heller or Electrovert
Electronics Forum | Wed May 13 15:26:45 EDT 2015 | cyber_wolf
We are high mix - high changeover aerospace manufacturer. We have 3 1809 MK3 air ovens. There has been absolutely no issues with them. We have 4 MPM Momentums. I looked at DEK but felt the MPM's were put together better. They are very easy to use