Electronics Forum | Wed May 26 05:36:28 EDT 2004 | Grant
Hi, Thanks for the info, and I had not considered some of these points. Is the CP-842 available? I have not seen any info on it? Regards, Grant
Electronics Forum | Fri Feb 27 15:20:44 EST 2004 | pdeuel
I have 6 base units of the Metcal PHAP-01 Hot air pencil. I do not have any handles or accessories for these bases. Metcal tells me that these units are obseleted and have been replaced with newer units that have a diferent conector. Is there out th
Electronics Forum | Wed Jun 23 10:05:17 EDT 2004 | exmaintenanceleader
Hi Grant, I'm ex Fuji service engineer I install also at Sagem Czecz Republik (Kladnow near Prague) in 2000 they use at new lines MPM- 2XCP643E and 1xUniversal GSM (French owen (I do not remember the exacly tipe) at second hand line they use 2x and
Electronics Forum | Tue Mar 19 10:27:06 EST 2002 | amir
in regards to repairing all these boards, do they consider the end cost of the product whether it's worth it to do so or not? if it does, would you be able to do it in house? and how labor intense is the job? there are machines out there for mass rep
Electronics Forum | Fri Feb 06 14:08:56 EST 2004 | Andrea
We consider two screen printer from MPM and it is type SPM and MicroFlex. How you compare these two machines. Our the smallest fine pitch is 0.5 mm QFP. Is it really worth to buy SPM or MicroFlex will handle with it without any problems.? And what ki
Electronics Forum | Fri May 07 18:05:28 EDT 2004 | valuems
Hello Sam The problem that you have is the software in the cognex box has to match the soft ware in the computer. Also the 3 1/2 floppy reader in the cognex box is a special made unit. Not just any 3 1/2 reader will work. The way we fix most of th
Electronics Forum | Thu Mar 18 12:32:16 EST 2004 | steve_arneson
There are many low cost paste inspection systems on the market today. It really depends upon your overall needs for process improvement. The CyberOptics LSM series of inspection devices use a single laser stripe to calculate both Height, Area and V
Electronics Forum | Wed Jul 21 10:05:22 EDT 1999 | Mark Quealy
| | | I recently switched from solder paste in 500 gram jars to 500 gram tubes. I did this to try to limit the time the paste is exposed to the room environment. But we have a need to clean the stencil every 4 - 5 boards which means taking the bulk p
Electronics Forum | Wed Jul 21 11:49:24 EDT 1999 | Deon Nungaray
| | | | I recently switched from solder paste in 500 gram jars to 500 gram tubes. I did this to try to limit the time the paste is exposed to the room environment. But we have a need to clean the stencil every 4 - 5 boards which means taking the bulk
Electronics Forum | Wed Dec 22 14:21:13 EST 2004 | James Dornan of APE Inc
A little late but if this subject is still of interest the following paper from APE may be of interestwhen considering IR to Air Bath: HOT AIR versus IR and other convection Rework Systems HOT AIR is the most popularly chosen method of rework in th
