Electronics Forum | Tue Aug 04 09:02:34 EDT 2009 | kpm135
We replaced the tactile sensor's linear actuator on a MPM Ultraprint 2000 HiE. Now we are getting a Tactile Hardware limit error every time we try to find the stencil height. I was hoping some one could explain why we're getting this error and any i
Electronics Forum | Mon Oct 20 15:28:22 EDT 2014 | island2013
We've got a set of manuals here for the AP series. If you would like to borrow them email me.
Electronics Forum | Sun Oct 12 22:08:34 EDT 2014 | cusackmusic
I just got a used AP/C which I guess is also called an AP25? After fixing a few obvious issues, I powered it up, and get a hardware limit error. I have verified that none of the axis are near their limits. Without a manual, I'm not sure where to go
Electronics Forum | Tue Oct 14 10:52:35 EDT 2014 | swag
Can't help you with the manual but do have some tips: If it was shipped, it's possible someone tied axis or blocked stuff for shipping. Look for that. Look for bent sensor flags + go into I/O and check to see all sensors you can find are working.
Electronics Forum | Sat Oct 18 22:41:54 EDT 2014 | pfifla1
Can't help you with the manual but do have some > tips: If it was shipped, it's possible someone > tied axis or blocked stuff for shipping. Look > for that. Look for bent sensor flags + go into > I/O and check to see all sensors you can find a
Electronics Forum | Wed Aug 05 14:20:21 EDT 2009 | jorge_quijano
Hello there, I'm having some problems w/MPM up2000, Vision Y axis software limit error, when I tried to create a new program, appears the "Value out of range for VY BSS POS, spec 0.00 min -26.5, read 8.45" message. Any idea of how to correct this pro
Electronics Forum | Tue Aug 04 10:19:38 EDT 2009 | swag
Here's a few ideas: If it has one, make sure the flexible coupler set screws are tight. Replace the tactile switch (often these appear to work fine in I/O but do not work properly in production). Clean and oil the tactile plunger if it has one. M
Electronics Forum | Tue Aug 04 13:44:05 EDT 2009 | swag
Check your DIP switch settings on new driver. Not sure about calibration. Try QMPM for password.
Electronics Forum | Tue Aug 04 14:43:12 EDT 2009 | kpm135
Thank you very much SWAG that password did the trick. Got us into the calibration menu and we were able to calibrate the z-axis and snugger height and got it to work. Thanks again
Electronics Forum | Tue Aug 04 10:43:48 EDT 2009 | kpm135
Thanks for the suggestions! It ended up being that a wire on the amplifier card in the lower drawer came loose and was making intermittent contact. Tightened all the wires down and the problem has gone away. Now we have a new problem. We had to repla
