Electronics Forum | Mon Dec 17 11:55:08 EST 2007 | chef
I recently had the same problems, solder bridges on every thing I made, different customers boards, etc. I wave with no-clean flux. As I sorted out problems (pin holes, blow holes, splatter, etc.) I found a lot of variable factors. I changed flux,
Electronics Forum | Tue Jul 19 08:26:46 EDT 2016 | pavel_murtishev
Aleksander, The answer is no. Solder deposit being printed is 80um-150um in height depending on PCB design what is two times higher than any track covered by solder mask. Molten solder will merely center the component. QFNs are prone to soldering
Electronics Forum | Tue Dec 10 14:10:38 EST 2002 | Randy Villeneuve
Steve, I wave solder most if not all our boards with selective wave pallets. I did not catch if the solder balls were on top of the board or on the bottom but that will make a difference on what to do to get rid of them. Pallets are good and bad. On
Electronics Forum | Tue Nov 01 14:46:31 EDT 2011 | davef
Agilent TestJet Technology White Paper In the early 1990s, the testing of digital parts became problematical. Previous in-circuit test techniques sought to ensure a correct, functioning part by applying digital patterns, called vectors, to the input
Electronics Forum | Wed Mar 12 16:20:51 EDT 2008 | hussman
Poor training. Don't blame the operator, he was either shown this or left to his own devices. Be the better man and provide him a better process. Regular old peelabale solder mask would be a start.
Electronics Forum | Fri Jul 15 13:28:55 EDT 2005 | Brian
A process consists of much more than just thee machine. When developing a cause and effect diagram ffor the process, there are many parameters that fall outside the machine itself. There are Man, Machine, Methods, and Materials. Just monitoring th
Electronics Forum | Mon Nov 20 04:04:42 EST 2000 | Gyver
Sirs, Please do me a favor to answer the following questions, thanks a million! 1. Will the baking of BGA or PCB cause more oxidation before the SMT process? 2. What is the acceptable Life Time of solderability at customer site? The time that the sol
Electronics Forum | Thu Nov 11 17:53:59 EST 1999 | Jeff Tamagi
I have read in some magazine articles that there is poor signal to noise ratio of RF devices when no-cean solder is used. The frequecies used exceed one Mhz? Is this true?
Electronics Forum | Wed Oct 26 14:20:41 EDT 2005 | TPM
Brian, We have the Mirtec Table Top. It is very good at detecting the component and orientation. It is however only as good as we program it to be. We have seen some limitations in respect to solder connections. I have not found it to be 100% re
Electronics Forum | Wed Dec 09 18:51:06 EST 2020 | johndep7
My company has been having issues with a lot of solder balls, solder splash, and flux balls all over a specific board. Now this is one of the only companies that require us not to clean our boards after our work is finished but this is also causing a
