Used SMT Equipment | Soldering - Reflow
Manufacturer: Quad Model Number: ZCR941 Asset Number: 5154
Used SMT Equipment | Soldering - Reflow
Mesh conveyor Top and bottom heaters (newer heaters) Cooling section Newer Blowers
Used SMT Equipment | Soldering - Reflow
Fully operational Quad ZCR 531B four zone reflow oven. Cooling fans at exit. Top side only heaters, 19" mesh belt only. PC controlled with DOS software. 208 three phase, 32A at start up. Includes software disk, operation and service manual. S
Electronics Forum | Tue Mar 10 10:31:50 EDT 2009 | tropical
Looking for electrical schematic for Quad zcr reflow machine. Tried PPM but no luck. Anyone have it?
Electronics Forum | Mon Oct 04 16:47:15 EDT 2004 | dgjjr
I'm looking for Quad ZCR 941 parts outside of the Tyco pipeline. Anyone know of a good reseller with access to Quad oven parts? dj
Electronics Forum | Thu Apr 27 11:12:32 EDT 2006 | tds
I have a Quad ZCR (4 zone) oven for $5,000. Edge/Mesh, auto chain oiler.
Electronics Forum | Fri Jun 03 14:55:15 EDT 2005 | Bman
Both our Quad ZCR and our Conceptronic HVN-102 ovens have had blowers out with no alarms raised. We knew there were problems based on how boards were soldering, but don't count on your oven to tell you if anything is wrong with it. We verify once a
Electronics Forum | Fri Jun 04 21:27:16 EDT 2010 | deanm
We have a 4 zone Quad ZCR 531B reflow oven with top side heaters only and a mesh belt. Our boards are 2-6 layer, range in size from 2x2 to 7x15, 0402 to D2PAK. What are the limitations/drawbacks of having top side only heat, especially since about ha
Electronics Forum | Thu Jun 23 09:23:05 EDT 2022 | richardcargill
Does anyone have any insight/experience with the Quad QCR942 reflow oven ? We've been offered one at a bargain price but are apprehensive about it being listed as only a 4 zone system. Cheers
Electronics Forum | Mon Apr 04 12:58:50 EDT 2005 | Roger @ Tyco [Formally Quad]
Passwords for the ZCR / QCR did change with the version of S/W. I believe that from version 2.9 onwards the password to start the S/W from the DOS prompt is "quad" [all lower case]. Pre version 2.9 please type "zcr" [All lower case]. This will enable