Electronics Forum | Fri Jul 06 18:17:34 EDT 2001 | davef
We find no solder balls after washing our boards. It works GREAT!!! ;-) Probably more to the point, look at "Circuits Assembly" 7/01, p 40, "Eliminating Solder Beads In No-Clean PCBs". "Solder mask type & composition are the greatest contributor t
Electronics Forum | Wed Oct 01 10:01:15 EDT 2008 | davef
We've never used the 99*C lead-free solder you mention. We have used a leaded solder that can form a 93*C eutectic solder. So, we had to be sure the service temperature [of the solder connections] as below 80*C.
Electronics Forum | Wed Jan 01 22:19:33 EST 2020 | sssamw
Solder ball attached on solder joint without violation minimum electrical clearance is acceptable. If your process parameter including stencil not changed, suggest you check if solder pasted being pushed out after IC placement, also check if solder j
Electronics Forum | Tue Dec 31 02:04:19 EST 2019 | sssamw
From the picture, I cannot see clearly solder ball violate electrical clearance or cause a short, maybe it is. What I can see is the solder paste has some misalignment although it doesn't printed in solder mask area, but actual position will reduce
Electronics Forum | Mon Jul 16 19:27:27 EDT 2001 | eliishee
I have no choice, as per customer's request to remove the solder balls. Can i use water to clean away the solder ball since i'm using RMA solder paste not the water soluable paste.
Electronics Forum | Mon Jul 16 19:36:09 EDT 2001 | steven
I hv no choice as per customer's request to remove the solder balls. Can i just use water to clean away the solder balls since i'm using RMA solder paste and not the water soluable paste?
Electronics Forum | Fri Jun 12 23:52:42 EDT 2015 | armandogomez
Reflow? or Wave solder? or selective wave solder? For what I understand you problems is with the preheaters you have a high temp that dries up the flux, and when hits the wave is doing that, do you have a thermal profiler? what's the temp just befor
Electronics Forum | Tue Dec 31 02:06:21 EST 2019 | sssamw
Yes, from the picture, it seems the gap between solder pad is very small, easy to have solder ball/solder bridge.
Electronics Forum | Mon Aug 04 23:25:28 EDT 2014 | madhuranatha
Let me thank you for the reply. We are manufacturing products which are fitted on the aircraft. We are using SN63Pb37 solder paste for PCB assembly. Of late one of the solder paste supplier recommended SnPbAg for better solder-ability & reliabi
Electronics Forum | Mon Aug 04 23:27:05 EDT 2014 | madhuranatha
Let me thank you for the reply. We are manufacturing products which are fitted on the aircraft. We are using SN63Pb37 solder paste for PCB assembly. Of late one of the solder paste supplier recommended SnPbAg for better solder-ability & reliabi
