Electronics Forum | Thu Sep 10 17:13:31 EDT 2015 | tombstonesmt
There are factors that manufacturers have taken into consideration when dealing with coating. On/off times, dispense speeds, heights, etc.. Dedicated software with tools to easily map out paths are a godsend. We made our own coating machine with a s
Electronics Forum | Thu Sep 20 03:31:42 EDT 2018 | minhhaioh34
Hi all, I need some pro help me with issue bubbles after coating. some information for some pro: Machine: Asymtek Chemical: Achime AVR80 Oven: IA 4 zoon4 ( setting 100 100 90 80 conveyor speed: 0.6 m/min). I had happened before and after the oven. W
Electronics Forum | Wed Jan 27 09:00:56 EST 1999 | Chris Fontaine
| | I have boards coated with Humiseal 1B73. At a late point mfg. site we need to remove a series of 0603 resistors for optioning purposes. I have been trying to determine the fastest, easiest way to re-coat the pads after removal. Drying time of the
Electronics Forum | Fri Jan 22 14:31:14 EST 1999 | Dave F
| I have boards coated with Humiseal 1B73. At a late point mfg. site we need to remove a series of 0603 resistors for optioning purposes. I have been trying to determine the fastest, easiest way to re-coat the pads after removal. Drying time of the c
Electronics Forum | Tue Jul 30 17:45:56 EDT 2002 | davef
What's this 'metalic coating on both sides'? Is that like a 'two-sided board'? I expect that your 200�F is the primary side temperature just prior to entering the wave. If not, you need more juice [depending on your flux and all that]. [Some mode
Electronics Forum | Wed Jul 31 17:25:39 EDT 2002 | sueph
Dave, thanks for the reply. These boards have metal plating covering 99 percent of both primary and secondary surfaces. The only places without the metal plating are the extreme outer edges and about an 1/8 inch surrounding the plated holes. We do
Electronics Forum | Fri Jan 16 10:54:21 EST 2009 | realchunks
Hi Steve, Make sure your spray head is all the way down. If so, try slowing your rate of speed over the part. Which head are you using to coat this part?
Electronics Forum | Mon Jun 25 10:59:49 EDT 2007 | simsj
We're using the 1B73LOC conformal coating from Humiseal. We've seen some bubbling of the coating. Their tech handbook suggested reducing our oven ramp speed. Does anyone have a good profile for this? They've always pointed me to Nordson, and Nord
Electronics Forum | Mon Aug 14 05:45:16 EDT 2023 | dimamalin
First, this is the result of bad printer setup. Adjust knife pressure, PCB gap, separation speed, tooling, and stencil cleaning. Pay attention to the coating of contacts pad and height of solder mask of PCB.
Electronics Forum | Mon Aug 25 14:55:51 EDT 2008 | grics
I have a question for the manufacturing masters... We are going to start running test trials/DOE of a Urethane Coating (Humiseal 1A33) and I am not sure what to expect. From what I understand, urethane coating is pretty difficult to work. It is supp
