Electronics Forum | Tue Mar 30 14:59:00 EST 2004 | Claude_Couture
no help from BTU, didn't buy from them so no support. I found the cause of the problem. The input of the controler relating to the conveyor alarm must have been stuck. By toggling the trigger value from Lo to High in the setup screen, I caused an ala
Electronics Forum | Thu Aug 19 09:38:24 EDT 2004 | russ
We use a locally made fixture that uses tooling pins and a mating block to place the connector onto/into. We then use a toggle clamp to push the connector onto the board. We had to make no adjustments to stencil for our application. Russ
Electronics Forum | Tue Jan 18 11:47:10 EST 2005 | clarkk
JB, I've toggled between front and back lighting and the results are about the same. But thanks anyway for the suggestion. Clarkk
Electronics Forum | Thu Apr 06 18:31:27 EDT 2006 | jsloot
Any one familiar with a board clamp problem on MPM UP3000? The one I have will not clamp the board when program is running. It will work when toggled through the output diagnostics. Any help is appreciated.
Electronics Forum | Tue May 17 11:12:09 EDT 2016 | bobpan
Press both buttons simultaneously. Press black button 3 times. Led will flash then go solid. This will toggle the pitch between 2mm and 4mm. have fun.
Electronics Forum | Mon Feb 04 17:53:58 EST 2019 | arbpkevin
My topaz X does the same thing. Hope someone can explain this. I have to toggle the button every single time after the first board.
Electronics Forum | Thu Jul 18 12:45:49 EDT 2019 | dekhead
Lots of things it could be (basics first): E-Stop pressed. Connections within E-stop circuit (mostly Y4). Connection of SYSTEM switch back to Y4. E-stop relay. Do double pushbuttons toggle partial SYSTEM?
Electronics Forum | Tue Aug 15 07:31:27 EDT 2006 | Chunks
Yes, when teaching fids and you get to the screen shows your fid (either board or stencil), hit the middle "roller button" labeled NEXT. This will toggle your bulb from regular to bright and vice/versa. If it's still very bright, the bulb itself ma
Electronics Forum | Thu Feb 15 12:34:11 EST 2007 | flipit
Does Ekra or MPM require stencil fiducials be filled with Black Max or some other black epoxy? We still require our stencil supplier to do this. I did not have to do this on any Dek solder printers since 1997. Can the MPM UP2000 HiE fiducial light
Electronics Forum | Sat Jun 05 09:24:40 EDT 2010 | dekhead
As stated, that error relates to rail lifted sensord (L & R)... Machine is perceiving that something is causing rails to lift at inappropriate time. You can monitor sensor status in Rising Table diagnostic to see that they are toggling appropriately.
