Used SMT Equipment | THT Equipment
Description: Manufacturer: Universal Instruments Model Number: 6796A Description: Uni-Mod Dip Inserter Serial Number: Unknown Input Power: 120V, 60Hz, 80 PSI,Single Phase Features: .300 Tooling, 20 PIN Clinch, Stand Alone, 8221 Controller
Used SMT Equipment | Other Equipment
Manufacturer: Universal Instruments Model Number: 6796A Serial Number: 53795-5-3A1 Description: Uni-Mod Dip Inserter Input Power: Input Power: 115V, Single Phase, 60 Hz, 15 Amp, 90 PSI, 3.5 SCFM Features: 18 x 18 Inch Rotary Table, 8222
Used SMT Equipment | Other Equipment
Manufacturer: Universal Instruments Model Number: 6796A Serial Number: 52284-5-3B13 Description: Uni-Mod Dip Inserter Input Power: Input Power: 115V, Single Phase, 60 Hz, 15 Amp, 90 PSI, 3.5FCFM Features: 18" x 18" Rotary Table, 8222 Co
Used SMT Equipment | THT Equipment
Manufacturer: Universal Instruments Model Number: 6796A Serial Number: 3A1-UM-1331 Description: Uni-Mod Dip Inserter Input Power: Input Power: 110V, Single Phase, 60 Hz, 15 Amp, 90 PSI, 3.5 SCFM Features: 18 x 18 Inch Rotary Table, 8222
Electronics Forum | Fri Oct 09 15:23:45 EDT 1998 | Claude Couture
I have trouble loading the executive file into a universal DIP inserter (model 6796 unimod). the start of the loading goes well, but stops at byte 5689. the "run" light stays off. Anybody who knows these machine will know what I'm talking about. I
Electronics Forum | Thu Feb 11 15:51:22 EST 2010 | baildl632
Universal Sequencer, VCD, Radial, or Unimod(DIP installer) machines! We only still have and run our Universal/Berg pinning machine. I can't say they will work any better than humans do as humans will have to run and maintain them though. We did get g
Electronics Forum | Thu Sep 02 19:22:08 EDT 2010 | fulldrawmike
seen it on a uni-mod many times. there is a muffler near that assy that if dirty will cause the air dump to back up and not exit out the muffler. if yours has one, remove it and see if it stops the table latch. it will be loud but it will let you k
Electronics Forum | Mon Sep 22 11:55:26 EDT 2008 | wrongway
you might want to check out panasonic they can handle a lot of feeders on one machine and are fast We have universal advantis machines have had them for a year have'nt had any problems yet. have not had universal calibrate them yet still placing par