Electronics Forum | Sat Nov 26 01:35:49 EST 2011 | haiae
Used spare parts is OK. Please tell me if you can offer. Thanks,
Electronics Forum | Fri Nov 25 16:06:59 EST 2011 | nick79
Hi Everyone, I'm new here,does anyone have the samsung smt cp45fv neo user manual ? I'm new,and working with it now,please help. Thanks in advance.
Electronics Forum | Tue Nov 29 11:09:59 EST 2011 | Shean Dalton
Siaomuay, What is your flux and peak reflow/rework temperature? Do you use chemistry in your cleaner? Regards, Shean Dalton
Electronics Forum | Wed Nov 30 09:19:57 EST 2011 | siaomuay
Dear Shean Dalton Peak temperature 240'c and we use IPA for cleanning Pcb surface before mounting
Electronics Forum | Tue Nov 29 21:45:34 EST 2011 | sonavc
Hi I have this SMT-1200E Suzuki . the system disk is bad. would someone copy me one. Please I do pay for your time . my email is son@enableit.com thank you for read my post Son Nguyen
Electronics Forum | Tue Nov 29 21:55:15 EST 2011 | brokenman
Anyone have any information Kanetic Inc. Bare Board Loader anything will be helpful. Th B
Electronics Forum | Wed Nov 30 14:27:27 EST 2011 | bobpan
The machine has linear servo motors. It has to be VERY level. You may want to check that this is the case. If this doesnt work.....make sure the encoder scales are clean. Good Luck
Electronics Forum | Thu Dec 01 16:11:03 EST 2011 | cowens
I have a MPM UP2000. When running or after teaching fiducials you will here a clank and the error "Camera not parked" will show. If anyone has experienced this on have any suggestions plaese advise. Thank you.
Electronics Forum | Fri Feb 03 12:25:34 EST 2012 | cyber_wolf
The camera is probably clipping the top of your board when it is reading fids. This causes the motor to lose steps. Manually load a board to vision height and drive the camera over the board to check for clearance issues.
Electronics Forum | Sun Dec 04 15:42:21 EST 2011 | ngineer
Thanks for the reply bobpan. I had the motor power on. I did have a side panel that was not shut all the way. Once I shut that, the error went away and it made it through its startup sequence. No errors. Thanks for the help.