Electronics Forum | Tue Sep 19 09:41:30 EDT 2017 | sumote
Steve, The 4 things I would do, and in this order: 1. Clean your stencil with stencil cleaner wipes after it comes out of the stencil cleaner. I like MicroCare ProClean (MCC-PROWR). I will even saturate the wipe with a bit of isopropal just till
Electronics Forum | Thu Dec 14 04:02:40 EST 2017 | spoiltforchoice
"I would expect that any intelligent feeder > enabled machine would pull the correct part no > matter where it is placed on the machine (not > forced by the program)" > > this is true, but you > have to tradeoff the setup time vs production > t
Electronics Forum | Fri May 11 16:06:09 EDT 2018 | aj
answers: The software on these machines is kinda flakey and the manuals are almost useless. There are a lot of bugs in the vision software that bite you. I supported mirea/meridian equipment at a past job and my memory is a bit fuzzy, but here are
Electronics Forum | Wed Jan 23 23:45:35 EST 2019 | kiransahu
Piezoelectric type (office/industrial) In this method, a piezoelectric (piezo) element, whose volume is deformed when voltage is applied, is used to discharge ink particles. This element is attached to the component that is filled with ink. Then, th
Electronics Forum | Thu Oct 18 08:27:46 EDT 2018 | spoiltforchoice
They visited our factory once bringing the desktop variant with them quite a while ago (~8 years perhaps when they were still called something else). At the time it was an FAI machine first and foremost with some "AOI like" features that perhaps o
Electronics Forum | Thu Aug 29 15:51:21 EDT 2019 | spoiltforchoice
&gt; If quality or Reliability is the key.... BTU, <BR> &gt; Soltec Vitronics..Rehm... If it is the money <BR> &gt; ...probably not these brands.....:) <BR> <BR> Well I
Electronics Forum | Wed Sep 04 10:10:10 EDT 2019 | jameshoward
I know exactly what your problem is as I have seen it many times. Your problem is with indexer 1 (the cylinder which runs up and down and actuates feeders on side 1). At each end of the travel of the indexer is a micro switch hidden down below the be
Electronics Forum | Sat Jun 27 17:49:24 EDT 2020 | jmelson
I can't find much info on the older Essemtec machines. First, I'd want to see the "spec sheet", then I'd want to find out what the programming environment is like. (I was really impressed with the Samsung machines in that regard.) I have not seen
Electronics Forum | Tue Mar 23 23:17:12 EDT 2021 | llawrence
Hello everyone, I work for a company that, up until now, has done everything using through-hole components. This has been fine for years, but we have been pushed into the world of surface mount manufacturing by a new product that is far cheaper and
Electronics Forum | Fri Jun 04 10:02:06 EDT 1999 | Chrys Shea
| | I'm encountering a new problem at my new company that I haven't encountered before in my past life - and that's Wave Soldering VIA holes. | | | | We've been getting a rash of defects that we call in this company, "insufficient solder in VIA hole