78915 amps results

Electronics Forum: amps (Page 3102 of 7892)

YesTech F1 speed

Electronics Forum | Fri Jul 19 12:58:13 EDT 2013 | rway

The review time varies depending on the product. But it could take anywhere from 10s to over a minute depending. That doesn't leave much time left on this new line. What AOI are you using now and with what equipment?

YesTech F1 speed

Electronics Forum | Fri Jul 19 14:20:19 EDT 2013 | dontfeedphils

I'm at a different, smaller company now. I'm using YesTech now as well, but only as post reflow inspection later in the process, no pre-reflow.

YesTech F1 speed

Electronics Forum | Fri Jul 19 14:54:41 EDT 2013 | dontfeedphils

I suppose I worded that poorly, we run a B2 bench-top unit later on in the process (QA area to be exact) so it isn't in line with anything and doesn't have to keep up with anything feeding it upstream. And we run Juki equipment.

Fuji IP-2 MTU servo alarm

Electronics Forum | Fri Jul 19 13:50:29 EDT 2013 | kdc45

Thanks for the link, however, I have this manual already and it only shows how to replace motors, belts and prox switches and to adjust for zero set. Appreciate your time and efforts. I did find that it is an OC alarm. Thanks again. Regards, kdc45

Printed Circuit's Shelf life

Electronics Forum | Mon Jul 22 17:29:03 EDT 2013 | jorge_quijano

I have Ag & ENIG finishes, for Ag I've seen some oxidation, specially if the bag is not sealed propperly. Is there any real due date for PCBs?

When are conveyors required

Electronics Forum | Mon Jul 22 16:51:31 EDT 2013 | navworx

Is it every ok to put the output of one machine at the input of another machine? For example, can a pick and place machine be lined up immediately after the paste machine. Or, is it recommended to use a conveyor between the two?