Electronics Forum | Mon Mar 29 16:19:28 EDT 2010 | rodrigo
Hi All, I just realized that our CP-6 is reading only two of three fiducials. Is this normal? The coordinates are not the same and they're numbered 1,2,3. We use the MCS30. I checked the proper data and I couldn't see anything that would cause it to
Electronics Forum | Tue Oct 12 09:52:18 EDT 2010 | dyoungquist
Obviously a totally clean floor is the best. So what if you have 1 particle of dust on your entire production floor? Is that 1 part per million (1 PPM)? or is that 1 part per billion? or 1 part per ???? How do you measure dust and come up with a
Electronics Forum | Sat Nov 20 15:18:40 EST 2010 | rodrigo
I did transfer the program from the MCS30. I noticed that next device numbers were changed in the F4G like you said (1,2,3). That was the first time I had wrong parts in the wrong locations (this is the second time) but I corrected the numbers to ma
Electronics Forum | Sat Feb 12 13:19:27 EST 2011 | tpappano
A simple trick I read either here or on another P&P forum is to use "Silly Putty". Place a small thin spot of Silly Putty on the top of the front conveyor rail, and put the machine in "manual" mode. Steer head #1 over the putty and lower it, leavin
Electronics Forum | Tue Oct 11 09:26:42 EDT 2011 | dilogic
For all of you that are using this version of GSM USOS, I've made a patch that changes default fiducial repair drop-down menu from "Reteach Fiducial" to "Alignment Done". We had a large batch of boards with lousy fiducials and it drove me crazy havin
Electronics Forum | Sat Dec 17 16:46:45 EST 2011 | eadthem
Startup current depends on your configuration. ours dose zones 1,2/ 3,4/ 5/ 6,7 last i checked it pulled about 40-55 ish on start up and 25-35 during run. our profile is a slow ramp till 170c then a fast ramp to 285c 280c(last 2 zones). 1707's
Electronics Forum | Fri Jul 06 04:55:59 EDT 2012 | ccgooi
I have fabricated a artwork of stencil on a mylar and make comparison on PCB and Stencil in order to confirm if there is any PCB stretching at both end. The results are comparable for both stencil and PCB without any stretching . So,I assumed that th
Electronics Forum | Fri Sep 14 03:43:16 EDT 2012 | mili
Hello!I have a delta wave with these problems:offtime of lambda wave tracking is too long and when modify offtime setting to a negative value for a fast stop on tracking position of lambda wave, the wave pass on stand-by with a delay of half of leg
Electronics Forum | Fri Sep 14 04:11:16 EDT 2012 | mili
Hello!I have a delta wave with these problems:offtime of lambda wave tracking is too long and when modify offtime setting to a negative value for a fast stop on tracking position of lambda wave, the wave pass on stand-by with a delay of half of leght
Electronics Forum | Thu Dec 27 13:04:58 EST 2012 | dyoungquist
From the temps you list, I'm going to assume you are using leaded solder. What type of oven profile are you using: Ramp-Spike or Ramp-Soak-Spike? I think you will have better results if you use the Ramp-Soak-Spike type of oven profile. Better chan