Electronics Forum | Thu Jul 10 08:18:15 EDT 2014 | emeto
I think what you are asking for is called First Pass Yield and for us that is in the upper 90s. It will depend on the board complexity and quantity - makes big difference if you run 10pcs or a 10000pcs. Regards, Emil
Electronics Forum | Fri Jul 18 04:58:33 EDT 2014 | alexeis
Hi, If you are working in high mix low volume, your machine time is very expansive. In this case you must rely on the programmer, people experience, and make preparations offline (like Setup etc.), so do not hold the line in vain. Best Regards, Ale
Electronics Forum | Thu Jul 10 09:41:37 EDT 2014 | bobpan
Can anyone recommend a top notch filter to remove oil from the compressed air lines. The filter will be placed before the machine. We have traps that catch .01 micron oil in the airline but it is still getting through to the machine. Thanks, Bob
Electronics Forum | Tue Jul 15 08:45:29 EDT 2014 | jeltez42
I am seeing a similar problem. We are using Orbotech AOI. I am trying to find a way to make the light source brighter.
Electronics Forum | Tue Jul 22 03:37:18 EDT 2014 | serkanxy
Please us OK/NG light. This is advace light.Especially when there are 402 black resistors and they are on dark green or balck pcb, this ligt is perfect. But, this is optional thing. You must contact with local distributor to activate this ligt.
Electronics Forum | Tue Jul 15 15:39:24 EDT 2014 | ahernand75
Hello, I'm looking to buy PCB magazine for my SMT process and would like to have feedback about Nikko products. Any comment about them is welcome and thanks in advance for your support.
Electronics Forum | Wed Aug 13 03:49:14 EDT 2014 | stgpcba
We can't provide you pcb magazine,but only PCBs if you interested. www.China-pcbassembly.com
Electronics Forum | Wed Jul 16 03:54:01 EDT 2014 | enfrafer
how much time in average do you spend in set up time? how much % of productive time do you waste in setup? what smd equipment do you have?
Electronics Forum | Wed Jul 16 08:07:13 EDT 2014 | emeto
I have seen it all. from OEM that has 12 assemblies and the setup is always on the machine to a 5-6 setups a day in a CM environment with small quantities.
Electronics Forum | Fri Jul 18 11:31:31 EDT 2014 | jagriffin
Thanks Mac! I have been doing a lot of reading and I think I understand me challenge ahead of me. I do however have a double sided assembly and the BGA's are on the second side. So I know I have to make this a quick build…. June