Electronics Forum | Fri May 02 16:40:11 EDT 2014 | jimmyboz
If the machine is throwing components at the "void" where the error should be, place a box. The standard rejection are quite small, large parts will not fit.
Electronics Forum | Fri May 02 19:02:21 EDT 2014 | mac5
You will have to open each parts Shape Data, Click on the Shape Process tab, Click on the Process tab, towards the bottom of the page under Error change the Dump Position to Box. This should work. Good luck.
Electronics Forum | Sat May 03 13:56:12 EDT 2014 | jyo_409
We are using TL431 in our most of the power supply circuits. Recently the power supply board is returning from the field due to TL431 component problem. Could you people, please suggest me what are the possible reasons for TL431 failure & trouble sho
Electronics Forum | Mon May 05 11:20:10 EDT 2014 | pankyb1261
Hi, I was wondering if there is a preferred source of the .635mm ceramic substrate specified in the J STD 002 Test S and if there is what is the typical size folks are using (3" x 3"?). Thanks, Rich
Electronics Forum | Tue May 06 11:26:52 EDT 2014 | aj
Hi all, Can anyone share the necessary info for printing 0201's? stencil Thickness, grade of steel, 1:1 etc Thanks in advance, AJ
Electronics Forum | Fri May 09 08:27:35 EDT 2014 | emeto
REduction of center pad is the key as well as the stencil thickness. Having too big opening on your stencil will sometimes lift the part from the pads. Always try to make windowpane and shoot for about 60% of the thermal pad to be covered as start p
Electronics Forum | Fri May 09 09:31:04 EDT 2014 | jorge_quijano
we are placing small QFNs with no major issues, but this one may not seem like a QFN with thermal pad... I'm attaching a picture of the component.
Electronics Forum | Sun May 11 17:32:23 EDT 2014 | bobpan
I have a procedure on teaching fiducials on the machine with and without cad. The manual does not tell you how to do this. Give me an e-mail address and i will send it to you. Thanks
Electronics Forum | Fri May 09 09:52:33 EDT 2014 | aj
http://www.murata.com/products/micromechatronics/feature/actuator/index.html not much info out there about them - will contact supplier but interested to know if anyone works with these .
Electronics Forum | Tue May 20 20:18:23 EDT 2014 | g2garyg2
Yes we solder them for a variety of customers. Your inquiry is not specific to what you are seeking info on.