Electronics Forum | Wed Jun 11 10:33:06 EDT 2014 | demzvill
Do you mean that pick up z height is taught too deep thats why it can possibly flip the next chip. I will check our machine if have the same setting as yours. Thank you for this thought.
Electronics Forum | Sun Jun 08 23:36:59 EDT 2014 | jasmine01
Hi Friends, is there any know issue in which Cisco WAN Card can be used for Cisco 2800 router? Does HWIC-1T WAN Card or HWIC-2T WAN Card suitable ?
Electronics Forum | Mon Jun 09 11:33:31 EDT 2014 | asksmt
Hello What is the Lowest clearance achiveable with Wave soldering i mean without getting solder shorts ? Thanks regards,
Electronics Forum | Tue Jun 10 11:42:01 EDT 2014 | rway
Your bottom-side joints look deficient in solder. It appears that less than 50% of the land area is soldered.
Electronics Forum | Sun Nov 09 11:44:57 EST 2014 | robertwillis
Just thought it may be helpful, my FREE 100 page ebook on Pin In Hole Intrusive reflow is available to download see http://pihrtechnology.com/ Also my book on Package on Package may also be useful for the future see http://www.packageonpackagebook.c
Electronics Forum | Mon Nov 10 09:29:30 EST 2014 | jorge_quijano
Hola Bob, in fact I made the proposal for the PIHR just after review your e-book, it helped a lot! Gracias!
Electronics Forum | Wed Jun 11 14:09:58 EDT 2014 | spitkis2
Is anyone running reflowing in a vacuum oven to achieve void free connections? If so, are there any issues you are experiencing with this process? What level / measurement of vacuum that you need to achieve for good results?
Electronics Forum | Thu Jun 12 00:20:41 EDT 2014 | jasmine01
How to limt my Cisco WS-C3560X-48T-S switch port to 128kb which running 12.2(55)SE3 ? Could anyone help with the IOS commands needed to achieve this ?
Electronics Forum | Thu Jun 12 00:27:29 EDT 2014 | jasmine01
How to limt my Cisco WS-C3560X-48T-S switch port to 128kb which running 12.2(55)SE3 ? Could anyone help with the IOS commands needed to achieve this ?
Electronics Forum | Thu Jun 12 15:29:58 EDT 2014 | jimmyboz
Sarge, Red army does not immediately make me want to help, anyway. What is the exact error displayed? There is a chuck open/closed sensor, if not made at the right time it will e-stop with some error that I don't recall. I assume this is on H1.