Electronics Forum | Fri Jul 01 08:52:11 EDT 2016 | davef
Borrow a gauge from one of the lines from your air compressor and add it into the line to your fluxer Go get um
Electronics Forum | Mon Jul 11 15:01:56 EDT 2016 | spitkis2
We get them from Omega and have been for the past 20 years. Tried "cheaper" TC's a few years ago from an Asian supplier and lets just say I learned my lesson. They started to short after about 5 cycles and were tossed. Stick with Omega!
Electronics Forum | Tue Jul 12 10:45:45 EDT 2016 | bradholland
I didn't get any jigs, no. I am based in florida!
Electronics Forum | Thu Jul 14 02:25:59 EDT 2016 | salini
Thanks Evtimav and davef... We are doing tar potting only over the moisture sensitive device (not all over the PCB) to make sure that it does not get effected by moisture. But am unable to test the reliability of the process. Continuous switching or
Electronics Forum | Fri Jul 15 10:56:43 EDT 2016 | emeto
You always follow the MSL label(I attached the table). 1. Use parts 2. Reseal the parts that left. If exparation date is getting close: 1. Use parts 2. Bake the parts left 3. Reseal
Electronics Forum | Thu Aug 25 05:58:13 EDT 2016 | tsvetan
Get the one with better local support, spares etc. Any machine can do the job, down time cost a lot
Electronics Forum | Tue Jul 19 12:19:19 EDT 2016 | dnelson_azp
We are trying get Mycronics manuals for old M15 and M19, can anyone point us in the right direction? Or better yet, supply pdf manuals?
Electronics Forum | Thu Jan 26 17:53:53 EST 2017 | flexocard
Hello, we although get a defect Kistech KT-300. I have some documentation but no squeegee. Both squeegee are missing. Please can you send me some pictures of your squeegees of the machine? I can send you some documents i found at the pc. best regards
Electronics Forum | Tue Aug 02 12:19:48 EDT 2016 | proceng1
Actually I considered that, but I was thinking to leave the fiducial pad bare copper. These are customer supplied boards, but hopefully they will be willing to make the change for the next spin. Any tricks for getting it to see the boards we alre
Electronics Forum | Mon Aug 08 15:47:15 EDT 2016 | jdengler
You may be able to get the specs from one of the used equipment companies that advertise here. Jerry