Electronics Forum | Wed Sep 23 13:20:02 EDT 2015 | emeto
Depends on the MSL(Moisture sensitivity level) and how far you will use them in production. Here you should be able to get all the answers: http://www.jedec.org/sites/default/files/docs/jstd033b01.pdf
Electronics Forum | Wed Nov 11 22:13:45 EST 2015 | jackzhong
Hi, if you seal in proper way, it is not necessarily to vacuum. we are specialized in moisture solution for electronics and components. Maybe we could give you some workable advice or solutions. If you are interested, contact me by Skype:dryplus1 o
Electronics Forum | Wed Sep 23 23:10:26 EDT 2015 | richardcs
Does any one have calibration jigs for a DEK265 LT, a full manual with schematic would be good as well?
Electronics Forum | Tue Sep 29 20:44:36 EDT 2015 | dekhead
I can probably help you with manual and prints. Please contact me directly. www.dekhead.com
Electronics Forum | Thu Sep 24 07:14:39 EDT 2015 | mrnollid
What is the tolerance for inspecting a 28 pin IC in a socket? If it's not sitting flat to the socket, what height is acceptable?
Electronics Forum | Thu Sep 24 07:25:34 EDT 2015 | anilwagh
I have Cyberoptics SPI SE300 Ultra machine purchased from auction. I need service/Electrical/Program manuals.
Electronics Forum | Tue Sep 29 14:54:03 EDT 2015 | bmalhi
Voltage retrofit require some wiring changes along with circuit breakers replacement. Please contact serviceNJ@hellerindustries.com to get the retrofit quot.
Electronics Forum | Tue Sep 29 18:20:56 EDT 2015 | ercdave1
Rob,. thank you very much for the reply. I will follow your recommendations and verify that the stop bar is not damaged or misaligned. I will also thank you for the info for the service . I will keep you posted. Thank you again. David
Electronics Forum | Thu Oct 01 12:37:54 EDT 2015 | deanm
If you are still looking for information I have a procedure that our company used that I could send you that should still work for the 4000C. Please post your email address.
Electronics Forum | Tue Sep 29 10:53:42 EDT 2015 | marlyn
Hey there fellow people with SMT issues... What's the proper procedure for soldering through-hole headers on the back-side of the PCB (pins poking out on same side as SMT parts)? ( Yes - I did the SMT side first and am now faced with LOTS of pin-poin
