Electronics Forum | Mon Oct 13 11:27:51 EDT 2008 | dwelch123
For 15 years I have used a similar method, only I used two bread pans. You can fit alot more solder in them. In one pan I drilled holes very similar to the photo in one pan and used a reclaiming agent such as Kleenox to prep it a bit. Then used the o
Electronics Forum | Tue Oct 14 10:03:17 EDT 2008 | dwelch123
The bread pans are stackable, same size at top but smaller at the bottom. I also do this inside the solder wave. Just press the other bread pan on top of the other. It helps to have some guns on you, some little stick boy might not squeeze enough, bu
Electronics Forum | Fri Oct 17 04:23:51 EDT 2008 | fujiphil
Check the image using the fast inching [F] and axis selection [2]. After vision error, press [F] then [2]. The monitor will display a binary images. You will now have a visual look on how the error occurs. Adjust the CCD level of the camera until you
Electronics Forum | Fri Oct 09 00:57:05 EDT 2009 | jjmag921612000
SteveO, I had personal experience with this using a Panasonic MPAV2B. It took a while, but I believe the end result was to have some additional "Z" travel to press the QFN into the paste. Also, the design of the paste on the ground was key to keep t
Electronics Forum | Thu Nov 05 16:38:45 EST 2009 | rdoss
I don't recall where the puff off setting is either, but i know there is one. Find it and use that along with extending your pressing time. This will increase the time in which the nozzle holds the component in the solder. That, along with the puf
Electronics Forum | Wed Jan 13 22:59:53 EST 2010 | goolash
The Central Controller software on our Quad IVc machine is refusing to allow me to add local fiducials. Essentially, I follow the manual's directions, and when I press 'N' for New, it asks me to enter the placement number. No matter what number I e
Electronics Forum | Wed Jun 02 11:58:20 EDT 2010 | palsingh
TDK RX-11 giving Absolute Encoder Backup Error (237-100) at start up. The machine resets pressing the button but gives X and Y axis hardware error while doing zero position. The X and Y axis does not even jog manually. I followed the manual instructi
Electronics Forum | Fri Jun 04 02:51:25 EDT 2010 | tomta
We have a DEK 265 printer currently down due to the rail system error. The message "Belt Motor Error. Rail lifted error, check tooling" pop-up when pressed run. I did remove all the support pins prior loading a new job. I also ran rail system dian
Electronics Forum | Mon Sep 13 15:47:44 EDT 2010 | dox
Somebody pressed the system set button and now the machine has an e-stop,lid open, and extraction error. checked the control relays and all is OK except one is not switching on. The cable comes from the FCU unit so suspect some config or settings are
Electronics Forum | Mon Sep 20 13:43:40 EDT 2010 | dman97
Hi, Yes I dont have any estops engaged. Like I said, I can press the system switch and I can hear the locks engage, but it will not give me an option to lower the hood. I have tried turning the maintenance key, but nothing shows up on the monitor.
