Electronics Forum | Wed Mar 22 14:17:53 EST 2000 | Paul Peterson
We're considering upgrading our existing Asymtek to the new Jet dispensing model. I would like to get feedback regarding robustness of this Jet dispenser, does it need more cleaning, how's the consistency, ect. If anyone has input for me I would appr
Electronics Forum | Wed Mar 15 01:20:08 EST 2000 | Dreamsniper
Do we really need not to locate vias underneath discrete components on a PCB that will be wave soldered after reflow even though we are using no clean process on our wave solder ? What are the possible cause and effect when locating Vias under discre
Electronics Forum | Wed Feb 16 20:51:37 EST 2000 | Jim
We have to place some LCC208's. The terminations are flush with the underside of the package, on an 0.5mm pitch. The pads on the board are flat tin. We'd like to get the part up in the air a little to provide some clearance for cleaning. Is there a w
Electronics Forum | Thu Feb 01 20:21:34 EST 2001 | huat
Hi, Currently, we use kapton tape to tape out the goldfinger at our area. We still experience solder at goldfinger area, suspected is from washing of misprint boards. Can someone advice me on what is the method being use to clean the goldfi
Electronics Forum | Tue Feb 13 06:31:48 EST 2001 | jackofalltrades
I have been tasked with the job of developing Fiber Optic Repair procedures, most importantly cutting and splicing. Cleaning and checking, we have procedures for already. Now for my question, does anyone know of a "How To" site that may be able to gi
Electronics Forum | Mon Feb 19 18:48:59 EST 2001 | davef
For smaller companies, it is difficult to justify the ~$35k cost of products in the class that you sell. On the other side of things, sloshing boards and stencils in a plastic wash pan containing flux thinner is not a good option either. Neither is
Electronics Forum | Tue Feb 20 15:30:23 EST 2001 | kerryn
We have a high-mix, low-volume type shop and clean over 50 stencils per day. The wash and rinse cycles in our aqueous stencil cleaner is ok, but the drying time takes too long (15 - 16 minutes per stencil). You indicate that hot air can damage a
Electronics Forum | Wed Feb 21 20:00:09 EST 2001 | davef
Sounds like you received some good advice. Most of our stencils are used once a day [at most], so more often than not they are air dried. If we goof-up and need to reuse a stencil during a day when we have limited drying capacity, we wipe the lowes
Electronics Forum | Thu Feb 22 12:42:02 EST 2001 | moncav
Dear SMTneter's; I am looking for a few board manufacturers to evaluate a new product. This device is a tooling fixture that conforms to any board profile for support during single or double side printing or placement. It's clean, simple and very r
Electronics Forum | Thu Mar 08 01:19:16 EST 2001 | Mike Moninger
The environment essentially defines the need for coating. "Inside" may mean inside a men's locker room with attendant high humidity or inside a climate-controlled clean environment. Conformal coatings offer protection against moisture, fungus, chemi