Electronics Forum | Mon Jul 09 08:35:55 EDT 2018 | pixel
I need the boot disk from Electrovert econopak plus 400/f! Anyone can help me, please?!?
Electronics Forum | Tue Oct 30 14:34:06 EDT 2018 | musmeran06
Hello, I need the boot disk for Electrovert InfraFlo 500C TurbAir. Can anyone help me please???
Electronics Forum | Tue Nov 10 19:20:34 EST 2020 | dekhead
Can you manually enter CMOS information in Setup and boot from there?
Electronics Forum | Thu Dec 03 17:56:59 EST 2020 | ravikumargv
Hi, Ip and mc host both pinging and no issues, but still sitest given communication error, for this i replaced communication card and lan cable as well. But machine software not booting at all... Regards, Ragav
Electronics Forum | Wed Apr 03 03:19:37 EDT 2024 | ddfreeze
boots with cmos battery low message. I do not see a battery anywhere to replace. F1 utility does not seem to work. hard drive is good. do not have an A: boot disk
Electronics Forum | Tue Dec 01 20:50:51 EST 2020 | tueftler
Hi there. Thank you for your reply. I have tested the VGA signal with two different VGA to VGA & HDMI converters without success. Now i have connect my oscilloscope onto the signal. RGB,V and Hsync...no signal at all after WinXP boot cycle. If i
Electronics Forum | Mon May 03 15:58:52 EDT 2021 | lt
Koh Young 3030 SPI machine. Has been running for the last 1-2 years. Now, it boots up as expected, up until the point where it should Home, but it does not Home. Any ideas what could cause it not to home. I know the older KY's are sensitive about
Electronics Forum | Wed Apr 19 16:43:05 EDT 2006 | samir
Silicone-based coatings "repel" most foreign,non-compatible materials like peelable solder mask, and rubber or vinyl boots. The result is, uncured material around the vicinity of where the boot was. Trust me. Been there and done that. As a rookie
Electronics Forum | Fri Mar 02 14:28:08 EST 2007 | stimpk
Chris, Can you boot in SiTest?
Electronics Forum | Mon Aug 31 09:53:59 EDT 2009 | fujiphil
after sending all the datas.... proper, program and status... Re-boot the machine...
