Electronics Forum | Fri Jul 24 16:33:45 EDT 2015 | cnotebaert
You should be fine! best practice for a situation like this would be to run a solder sample, either flux it and run through wave, or screen print, don't place parts and run through reflow. look for proper wetting characteristics if you see de-wetting
Electronics Forum | Sat Sep 22 02:14:08 EDT 2007 | mika
Another thing to make sure of and the vision calibration system will fail if this is out of range: Use a magnet foot stand micrometer and measure the spindle run outs. First remove the nozzles and nozzle adapters, then put the adjustable tip (I dont
Electronics Forum | Sat Sep 22 01:30:31 EDT 2007 | mika
I am sorry my friend, but I can't recall that specific error number. But it would help if you explain a little bit more about your problem. Remember that an error code Do Not necessary points to a direct root-cause of a problem. First of all we nee
Electronics Forum | Thu Oct 06 17:34:07 EDT 2011 | jrsmachine
Hello Tom. Thks for your response. I tryed all your suggestions. No luck. This is how it happened: Several weeks ago I allowed an inexperienced unsupervised operator to work on some program changes. When I checked back afew hours later I noticed
Electronics Forum | Tue Dec 15 06:07:53 EST 2009 | joelinacio
I need to know what is the sot-23-5 in the dmm fluke 189 with the code t6g. It is wired with the com conector.
Electronics Forum | Tue Mar 21 16:16:51 EST 2006 | gipos
Dear All, We shall be more than thankfull if someone who worked with Universal IR reflow-curing owen (model 4816 CRS) can help. The owen is powering up but needs 4 digit acess code. It is acquired from a closed factory. Maybe it dose have some secr
Electronics Forum | Tue Mar 28 14:25:36 EST 2006 | vickt
Mike, These ovens were originally manufactured by ETS...I think you can still get Tech support from that at either 763-553-0051 (MN office) or 509-276-2015 (WA office). Best of luck. Todd
Electronics Forum | Fri Jul 07 12:42:42 EDT 2023 | ttheis
We checked the three pacsci pc800 servo controllers and they all look OK, no red or error lights. VRM amps all look OK. Still haven't found the issue.
Electronics Forum | Sat Jul 08 02:21:40 EDT 2023 | unsung
I did clean the gold strip and black encoder box pretty good it took me a few trys but it work ( it did had rust on the machine from the rain I guess... from being out side for awhile)
Electronics Forum | Tue Jul 11 18:19:18 EDT 2023 | unsung
You're welcome hope you repay it by helping someone else here.