Electronics Forum | Mon Feb 20 07:57:53 EST 2006 | dpmilk
Thanks Rob. We've been in contact with Coilcraft, but haven't gotten anywhere, yet. We'll check out the other coils. We started using Coilcraft because of their high Q.
Electronics Forum | Fri Oct 19 07:27:09 EDT 2007 | fredc
I just looked in my MSC Industrial catalog and they have coils of shim stock which would be a hard temper in .031 thickness on Pg.1770. Also stainless sheets of cold drawn material .03 thick on page 1791.
Electronics Forum | Wed Jun 16 15:39:15 EDT 2010 | mikesewell
Keep in mind you'll still need to preheat the assembly to properly activate the flux/drive off volatiles in the paste. Perhaps a convection toaster oven... Add some cooling coils and a freeboard/tube to the top of your pasta cooker or turkey fryer t
Electronics Forum | Mon May 06 14:34:33 EDT 2013 | mbb
Hello, I'm looking for a supplier of red antistatic empty coils . Thank you to email me any suggestions.
Electronics Forum | Wed Feb 08 08:29:41 EST 2017 | dleeper
Ry-n, Yes, this applies to Heller ovens. I had the exact same problem. The SSR failed and current continues to flow through the heating coils until it triggers an emergency shut down.
Electronics Forum | Mon Sep 18 01:47:18 EDT 2017 | bukas
I would go with wire thickness + 0.4 to 0.8 mm for pad width, and pre-tinned lenght + 0.5mm what seems to me like problem is that it can easily roll off the pads in reflow oven
Electronics Forum | Mon Aug 06 14:12:49 EDT 2018 | tey422
I just found out we are unable to epoxy it. As the customer need to pull it up and open to tune the product. Which means the only way to solve it is by fine tune the pad and/or stencil design.
Electronics Forum | Tue Aug 07 16:11:49 EDT 2018 | kahrpr
we did something similar in the past but the leads had a L shape on the end which kept them stable.
Electronics Forum | Tue May 18 08:55:06 EDT 2021 | compit
I bought similar (KOGANEI) for Topaz-X, only the coil of the electromagnet must be the same (voltage). The mechanical part is unlikely to break down - you need to disassember and clean.
Electronics Forum | Wed Dec 15 18:03:28 EST 2004 | russ
I have used both 4 and 5 mil stencils for 10 mil round apertures. We don't have volume measurement capability but we measure height and the 4 mil appeared to have more paste and better uniformity from a visual standpoint than the 5 mil. The unfortu
.gif)
