Electronics Forum | Wed Nov 25 12:33:16 EST 1998 | Scott Snider
| A buddy of mine has problems after depaneling double sided pre-scored PCB's. Resistors near the edge, after put into the slice and dice machine contain micro cracks. He's checked for them before and after depaneling. We figure it is the sectioni
Electronics Forum | Fri Jan 26 16:24:10 EST 2007 | Bob R.
Whether there's a fillet or not depends on the component type. Most have a fillet but some, such as QFN's, don't necessarily have one. Have a look at IPC-610D Workmanship Standards to understand when you should expect one and when you shouldn't. T
Electronics Forum | Wed Jan 26 12:22:52 EST 2000 | Mikel Rodriguez
The diode doesn�t appear completely broken. It takes a bit white color (cristal break, I think), instead of the normal red/orange. It works like a 20K-200K ohm resistor. !The diode can be working properly and sometimes change to bad! I think it may
Electronics Forum | Fri Jul 04 21:09:04 EDT 2003 | ramanandkini
I have a CEM-1 PCB board with 35 microns copper. This is PCB is finished with SMOBC+HALS. We do solder SMT LEDs, but till date we do not have problems that you have listed. The LEDs are good & bright. It even passed high & low temp cycle tests (-40 t
Electronics Forum | Sat Jun 12 10:46:32 EDT 1999 | Dean
| Our company is experiencing cracked caps at our pick and place operations. The caps are being placed onto epoxy dots for subsequent wave solder operations. At present, be have set the pressure of the head at 2 in/lbs. This being down from manufac
Electronics Forum | Sat Jun 12 16:33:52 EDT 1999 | JohnW
| | Our company is experiencing cracked caps at our pick and place operations. The caps are being placed onto epoxy dots for subsequent wave solder operations. At present, be have set the pressure of the head at 2 in/lbs. This being down from manuf
Electronics Forum | Tue Nov 24 13:51:23 EST 1998 | Michael Allen
What kind of "slice and dice machine" do you use? I assume you're referring to what I call a score-breaker -- a device to separate the board from the panel (or from the adjacent board) by crushing the score-line WITHOUT bending the panel or the boar
Electronics Forum | Thu Sep 15 11:28:11 EDT 2005 | LeeHoMa
hi Steve/Pete, Thank for your email to affirming our current mounting and soldering flow! In fact, I also don't see any problem for the pilot run(though in small volume - 500pcs). However, the problem is - I am challenged by my customer that the AI
Electronics Forum | Thu Jun 17 10:37:42 EDT 1999 | Brian Wycoff
| | | | | Our company is experiencing cracked caps at our pick and place operations. The caps are being placed onto epoxy dots for subsequent wave solder operations. At present, be have set the pressure of the head at 2 in/lbs. This being down from
Electronics Forum | Thu Jun 17 11:18:03 EDT 1999 | Ian Clelland
| | | | | | Our company is experiencing cracked caps at our pick and place operations. The caps are being placed onto epoxy dots for subsequent wave solder operations. At present, be have set the pressure of the head at 2 in/lbs. This being down fr
