Electronics Forum | Fri Jun 21 12:49:58 EDT 2002 | surinder
Hi Russ, Thanks for your input.My board has SMT Chip components, SOT23,SOIC's & 2QFP (25MIL PITCH). Also,taking consideration that the board is well design for Wave.This board has been designed end of last year. We have latest model of Electrovert ma
Electronics Forum | Fri Dec 18 12:14:10 EST 1998 | Brian Steelglove
| | Does anyone out there have one we are currently looking at one from a used equipment dealer and would like to know how they work? Good or bad for SMT? | | Good or bad for high volume Thrue Hole? | | | | Thanks Again, | | Brian Steelglove | | A
Electronics Forum | Fri Dec 08 21:26:44 EST 2006 | billwestiet
You already have some good answers. A chemical isolation zone for RMA is a good idea. If you are looking for new see the two references you have and Austin America. If you are looking for used, see us at http://www.ietechnology.net. We presently
Electronics Forum | Sun Mar 06 20:08:38 EST 2005 | mrduckmann2000
Davef, You have a good question. If we had perfect design engineers out there that would use the proper component spacing and not put SMT parts between and around thru-hole parts - glue and wave would work perfectly. I have done this with great su
Electronics Forum | Thu Oct 13 15:41:30 EDT 2005 | lyrtech
Hi, We have a customer who give us a 20K board contract each year. It's only thru-hole components.The baord is HASL plated. So we pass it into our wave. No problems. Recently, our customer decided to go into GOLD PLATED finish. We take the same re
Electronics Forum | Mon Dec 21 08:49:29 EST 1998 | Aric Parr
I used one on SMT at a previous employer. Make sure that you have 3 zones of preheat. Make sure that your operators are trained. The airknifes are extremely difficult to set up properly. Don't use them on high mix lines. We didn't need them once
Electronics Forum | Tue Dec 22 10:00:31 EST 1998 | Chrys
| | | Does anyone out there have one we are currently looking at one from a used equipment dealer and would like to know how they work? Good or bad for SMT? | | | Good or bad for high volume Thrue Hole? | | | | | | Thanks Again, | | | Brian Steelg
Electronics Forum | Tue Sep 07 12:33:03 EDT 1999 | Mike Konrad
You are correct in your assessment that no-clean pastes are difficult to clean. I understand why you would need to clean lots of stencils, but why would you need to clean "high volumes" of PCB's? If you are planning on cleaning high volumes of PCB'
Electronics Forum | Fri Dec 18 10:00:19 EST 1998 | Chrys
| Does anyone out there have one we are currently looking at one from a used equipment dealer and would like to know how they work? Good or bad for SMT? | Good or bad for high volume Thrue Hole? | | Thanks Again, | Brian Steelglove | American Prec
Electronics Forum | Tue Oct 18 17:06:04 EDT 2005 | stepheniii
At one time I could show you the spacing of the chain of an electrovert but the burn marks have dissapeared. The center support chain would wrap around and jam up and with boards in the oven.............. On that one for some reason we bought it wit
