Electronics Forum | Fri Feb 07 20:38:16 EST 2020 | orbitcoms
I am running a Sasmsung CP40-LV machine (which itself works fine). However, the thing holding up production is that I am often experiencing tape cover not being pulled back by the feeders. What part of the feeder is most likely to cause this? I have
Electronics Forum | Sun Feb 09 18:20:24 EST 2020 | richardcargill
Does this only happen with certain feeders or certain components? We have a few regularly used components that experience the same problem ( Philips SMT machinery ) where the cover tape is just too sticky. Experience taught us which components will c
Electronics Forum | Wed Mar 20 12:59:10 EDT 2013 | kmots15
We had this issue with a few parts on our universal 8mm feeders. The set up was correct all mechanisms were working, even tried a new feeder. The spring in between the take up wheel and pick point just wasnt cutting it since the adheasion was too m
Electronics Forum | Wed May 03 13:27:32 EDT 2023 | dilogic
Genesis should work with pneumatic feeders, but not if Lightning heads are used. It's basically 24V transformer and some wires and fuses - you can do this "upgrade" by yourself, actually. Regarding cal. kit - it's the same as for GSM's but, again, no
Electronics Forum | Mon Oct 09 14:09:06 EDT 2017 | ilavu
Make sure that you have some feature on the part to get orientation check. We tried long time ago and it did work on GSM with 4 spindle. For us, setup the vision system was the challenge for correct rotation using vib feeder.
Electronics Forum | Sat Feb 03 10:51:47 EST 2007 | Sami
Hello to all. I have faced with a strange problem with Universal machine GSM Genesis, After an 8 hours of production without a Stop then, the M/C starts displaying components non aailable for many feeders in the same feeder bank! eventhough the feede
Electronics Forum | Fri May 04 08:53:48 EDT 2007 | davem
I have been working with the UIC GSM platform for 6 years now in an EMS environment. Operating, programming, configuration, and line installation. I do not work for Universal or represent them in any way. UIC is a 1st rate company with excellent and
Career Center | Lapu-lapu, Cebu Philippines | Engineering,Maintenance,Production
Sept. 2, 2009 to Present, TPM2, LEAR Corporation, MEPZ-1, Lapu-Lapu City • Provides SMT engineering support to day-to-day manufacturing operations. • Handles SMT pick-and-place machine (Fuji, CP7, CP6 and QP242 Series, Universal Genesis GI-14D). •
Career Center | noida, India | Maintenance,Production,Technical Support
Over 16 years of experience in Assembly Line Production, PCB, SMT, Process Improvements, testing & troubleshooting, time and motion study, Value– Engineering as well as Quality in varied industries
Career Center | noida, India | Maintenance,Production,Technical Support
Over 16 years of experience in Assembly Line Production, PCB, SMT, Process Improvements, testing & troubleshooting, time and motion study, Value– Engineering as well as Quality in varied industries