Electronics Forum | Tue Jun 21 07:44:13 EDT 2005 | bobpan
Usually the machines come with a manual that lists the error codes. Does the error happen at random??? Is it related to one head??? What does the error say in Mr. Terminal??
Electronics Forum | Thu Jan 07 18:34:51 EST 2021 | tamcrocker
Hello, I have an UMG VCD-H that is currently stop working due to a message " head Zero switch error" when retracting. I would like to know how to clear this message.
Electronics Forum | Sat Dec 01 18:08:03 EST 2007 | jmelson
Hello, I just ran into a crazy problem with my CSM84. I did a batch of one side of a board, then loaded the program to do the top side, and it stops with the head over the 3rd component's feeder, and reports error 117:overflow. The maintenance manua
Electronics Forum | Fri Dec 16 15:23:04 EST 2005 | Csabee
I think the Samsung SM320 is quite good machine..But I suggest that must assembly feeder cover to the feeder trolleys, because without that the tape feeders are not safe for the heads. Feeders should broke the head. chip components wrong light sett
Electronics Forum | Mon Jan 21 07:01:02 EST 2013 | ericrr
I can not believe this, We get back from Summer holidays turn on the first machine Juki KE750L goes to do a home and before the head moves, Error notice: rear feeder rise error, I go around the back, nothing out of place. but notice the receiver end
Electronics Forum | Thu Jan 12 20:54:30 EST 2023 | cbeneat
When I see that on ours, I take the nozzle off and clean the tip. Any build up and the machine throws that error. Do a set check on the head and then look at the image of the nozzle in question...OR we hit resume and the machine ignores it until the
Electronics Forum | Thu Feb 20 13:25:18 EST 2014 | brendansales
Dear Rob, Thank you for your quick response! There were Z locks on the Midas head area, 2 little solenoids like you mentioned. Previously I had the first error code (F-AXIS-C/9) and after fiddling around, randomly manual unlock the Z locks it came
Electronics Forum | Wed Feb 13 14:06:35 EST 2019 | slthomas
My recollection is fuzzy, but don't the heads go down first, then the nozzle? If that's true, did you fire the heads only or both the heads and the nozzles?
Electronics Forum | Sat Dec 17 02:37:21 EST 2005 | manyhats
Hi, it seems like you have some experience with the SM320... How do you feel about the reliability, and consistency of it? does it generate alot of error on a run? and what do you mean about feeders breaking the head? Also you're telling me that this
Electronics Forum | Tue Feb 12 14:13:56 EST 2019 | aldrich17
We executed that in IO screen all heads went down, N2323 sensor remained 0. And we cannot find N2223 sensor in the I/O screen. So now we are unsure of the issue but we are searching our manual in the "Placement Head" section hoping to come out with a