Electronics Forum | Wed Jul 17 12:07:48 EDT 2002 | dragonslayr
DaveF is correct in directing you to the archives. This problem type has been discussed many times, it is quite common. Questions to ask yourself and provide us with answers are: It always happens or random? All assemblies or just one? solder paste
Electronics Forum | Thu May 21 09:54:07 EDT 1998 | Justin Medernach
| I'm reviewing my board fab spec. It calls for a minimum SnPb thickness of 50 microinches on HASL PWB's. I've looked at other specs that call out anything from 30 to 80 microinches, and others that just say the copper pad must be covered and solde
Electronics Forum | Tue Dec 12 17:54:04 EST 2000 | ralph
I've had this problem myself, though in using water soluables. But the process to eliminate it is still the same. There are three possible causes for this to occure. Too much humidity, to much solder, and too much heat. Are you leaving the paste
Electronics Forum | Wed Mar 17 19:58:00 EST 1999 | Marc Ruggiero
Hi folks, I am looking for inputs on a long-standing problem encountered in our shop: Bottom-side parts (passives) falling off in the Wave...where the only remnants of the part is a flattened glue dot of proper diameter and volume, and sometimes f
Electronics Forum | Fri Mar 19 05:08:24 EST 1999 | Vinesh Gandhi
Hey Marc, I am not sure about the kind of process you are following. Is it Gluing+paste printing on the bottom side or just gluing on the bottom side and paste printing on the top side. The relationship which I could think of between Bottom side
Electronics Forum | Thu Mar 18 18:40:15 EST 1999 | Marc Ruggiero
| | | Hi folks, | | | | | | I am looking for inputs on a long-standing problem encountered in our shop: Bottom-side parts (passives) falling off in the Wave...where the only remnants of the part is a flattened glue dot of proper diameter and volum
Electronics Forum | Tue Dec 21 17:58:44 EST 1999 | Brian W.
When doing PIH processes, it is critical that you control the solder VOLUME, not the height. You must define the process, monitor it and control chart it to keep the paste volume consistent. You have do some careful engineering to determine how muc
Electronics Forum | Mon Dec 13 05:43:27 EST 1999 | Wolfgang Busko
Hi Steve, 20 mil pitch shouldn�t be that problem nowadays. In your case bridging and poor wetting seem to go hand in hand. For the poor wetting try to eliminate it by using different paste (higher activated) and work on your profile. Coplanarity also
Electronics Forum | Thu Mar 18 17:18:22 EST 1999 | Earl Moon
| | Hi folks, | | | | I am looking for inputs on a long-standing problem encountered in our shop: Bottom-side parts (passives) falling off in the Wave...where the only remnants of the part is a flattened glue dot of proper diameter and volume, and
Electronics Forum | Thu Mar 18 13:54:30 EST 1999 | John
| Hi folks, | | I am looking for inputs on a long-standing problem encountered in our shop: Bottom-side parts (passives) falling off in the Wave...where the only remnants of the part is a flattened glue dot of proper diameter and volume, and somet
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
