Electronics Forum | Tue Oct 19 19:25:40 EDT 1999 | Jeff Sanchez
Carol, I think the guys are right about you stand off problem but I want to address the wrinkleing of your masking. Although I think the temps you are subjecting the board to are very high and more than likely creating problems of their own. I th
Electronics Forum | Fri Sep 27 08:12:19 EDT 2002 | yngwie
Dear all, My customer is asking me to add chevron solder mask registration marks to their board design, drive fabrication capability study from their board vendor(s), and make sure tolerances are established correctly for copper traces and solder mas
Electronics Forum | Wed Jan 05 16:46:44 EST 2000 | Dennis O'Donnell
Several methods work well. 1. (Low Volume Method) Using an Xacto blade, scrape off the solder mask holding the blade flush being careful not to use the pointed part of the blade. 2. (High Volume Method)Tape off the area that you don't want the mas
Electronics Forum | Sun Sep 26 05:27:35 EDT 1999 | Edmund
i had a problem here, during the wave soldering process, we apply a water soluble mask on the gold finger to protect it from contamination. But after washing, there is still some mask left on the gold finger. Can anyone pls advise is there any parame
Electronics Forum | Wed Aug 22 16:00:02 EDT 2007 | razor1
The color variation in the solder mask from our PCB supplier varies to the point that we have problems with our AOI recognition and accuracy. We have not been successful at finding an industry spec which outlines solder mask color requirements. We
Electronics Forum | Sun Sep 26 11:54:06 EDT 1999 | Earl Moon
| i had a problem here, during the wave soldering process, we apply a water soluble mask on the gold finger to protect it from contamination. But after washing, there is still some mask left on the gold finger. | Can anyone pls advise is there any pa
Electronics Forum | Thu Jul 12 20:53:59 EDT 2001 | davef
Hussman: Please help us understand how knowing the profile will point us in the direction of how solder got under solder mask.
Electronics Forum | Fri Sep 27 10:54:55 EDT 2002 | yngwie
Thank you pr. It was much appreciated. Is this mark normally act like a global fiducial/local fiducial for mBGA ? Is this a standard mark that can be read by the placement machine? what is the typical size of this mark ? are they masked ? thank y
Electronics Forum | Wed Aug 17 14:30:58 EDT 2005 | russ
I usually see this with mask that is not fully cured from the PCB shop. This probably agrees with the baking statement that you made.
Electronics Forum | Tue Oct 19 19:44:19 EDT 2010 | laen
I'm looking to mix up a batch of purple solder mask. Has anyone found a good ratio of red and blue that produces a pleasing purple? 50/50 produces a pretty ugly grape color. Is there a standard ratio most fabs use?
winsouce.jpg)
