Electronics Forum | Fri Mar 11 10:47:24 EST 2005 | thaqalain
(1)While fixing feeders to reels ,some small componets are displaced or fell down out of reel and there will be discontinuty.In-fact there will be probability of this till we load magazines to machine. Is there any effect, I mean ultimately,will we g
Electronics Forum | Fri Mar 11 12:04:15 EST 2005 | thaqalain
Thanx JB, we have MY DATA MACHINE AND CONCEPTRONICS OVEN
Electronics Forum | Fri Mar 11 11:40:23 EST 2005 | JB
If there is an empty pocket at the pick up position, because a component "fell off" then the pick and place machine will attempt to pick up more components from the same feeder an "x" amount of times, depending on your component parameters, then it w
Electronics Forum | Fri Mar 18 14:27:29 EST 2005 | pmd
Hold on, MyData can place no component and not detect error if the minimum and maximinum settings in the centering phase are within the mesurement of the tool it'self. Especially if the levels are down between the jaws. For insurance make sure the to
Electronics Forum | Thu Mar 17 06:56:41 EST 2005 | Grant
Hi, Even if you don't use vision or a HYDRA head, the MYDATA should still sense no component, and try 3 times by default. Also, if the MYDATA does not place the component it will not be marked as places, so the placement program won't ever finish. Y
Electronics Forum | Fri Nov 08 18:36:31 EST 2002 | leeloo
Nowadays I have a problem, I am in chsrge of the section of smt in my company, have a normal process inside my department with a minimal level of mistakes, the problem happens when the material is liberated to the lines of production on happened for
Electronics Forum | Tue Aug 12 08:34:31 EDT 2008 | rameshr
hai, in our smt process we are facing the following problem. The Case A tantalum capacitor used in our PCB assembly - during reflow process get shifted, due to which other components nearby that also found missing. what are the causes for this proble
Electronics Forum | Mon Jun 14 15:50:07 EDT 1999 | JohnW
| I am looking for more information about: | | 1) What kind of evaluation can I do to measure the resistance to fall off of a bottom side glueded SMT component?; | | 2) There is some influence of doble wave solder machine (temperature, flux, etc) i
Electronics Forum | Thu Jul 15 22:19:04 EDT 2004 | KEN
Yep, but its hard to contol small parts with the bags. They're good for DIP's and sockets, connectors, but radials are kinda hit and miss. I bought mine from Pentagon EMS. They only use the finest european leather (kidding). PENTAGON EMS 10950 SW
Electronics Forum | Tue Sep 26 11:05:44 EDT 2006 | slthomas
You might also have a dirty/sticky Z-rod resulting in the same problem, although ordinarily you'll see a lot of missed pickups as well.