Electronics Forum | Tue Sep 13 02:31:50 EDT 2016 | bukas
board input sensor sensitivity? maybe conveyor movement triggers it and because of that it sends pulse. conveyor moves few millimeters, how does machine act?
Electronics Forum | Tue Sep 13 07:32:51 EDT 2016 | bukas
that sounds like bad relay or relay control. are you in position to check it on relay pins? I would go from there.
Electronics Forum | Wed Sep 14 23:30:30 EDT 2016 | ariss_t
Hi, my 2cent.. u could try to check the sensibility of the camera board stop sensor.. maybe it detect something i.e support block.. do reply when u found the actual root cause.. thanks..
Electronics Forum | Mon Aug 14 11:30:25 EDT 2006 | SWAG
We had centernest to I/O track alignment problems that were not predictable on 3000. Z-axis height seemed good with relation to I/O tracks but y was misaligned. Ended up replacing y-axis stepper and trouble went away. Also have had trouble with z-
Electronics Forum | Tue Oct 13 08:09:53 EDT 2009 | kudamarani08
Can anyone help me recommend or simulate a SPI and AOI machine that can balance our FUJI NXT 1 with 14 modules. We are using MPM accela printer. 200 UPH is our target. Here's the PCB dimension length(x) = 399.92mm width(y) = 141.626mm Thanks all!
Electronics Forum | Wed Sep 14 02:41:49 EDT 2016 | bukas
here is well explained SMEMA interface http://www.daghee.com/?p=326 so, disconnect printer from upline modules and check are any 2 of 4 pins shortened(should be pins No 1 & 2) while machine is ready state. when machine is in busy state the same pin
Electronics Forum | Thu Sep 15 06:45:26 EDT 2016 | awhite
Hi Ariss_T, Thanks! I actually did check that...that was one of my first thoughts as well. While in the I/O, I slide a raw board back and forth under the camera/sensor and it acted appropriately. I will definitely update this thread as new informa
Electronics Forum | Mon Dec 08 16:10:02 EST 1997 | Donnacha Nagle
Q1. As part of a Final Year Thesis I am currently undergoing an in-deph study of the Screenprinting process for MPM 3000 Screenprinters. Ultimately I will be setting up control charts on line. Does anybody have suggestions in this area ?, I have alot
Electronics Forum | Tue Oct 13 22:56:22 EDT 2009 | cpcompany
Can anyone help me recommend or simulate a SPI > and AOI machine that can balance our FUJI NXT 1 > with 14 modules. We are using MPM accela printer. > 200 UPH is our target. > > Here's the PCB > dimension > > length(x) = 399.92mm width(y) = >
Electronics Forum | Tue Sep 13 10:00:27 EDT 2016 | awhite
Switched out the mech. relay on the board loader, no change. Same behavior. Could not find a mech. relay on the printer... SMEMA wiring appears go directly to a PCB. And it is at that point that I run out of talent. If the machine weren't dedicate
.gif)
