Electronics Forum | Wed Sep 11 20:36:04 EDT 2013 | action_101
UIC still manufacturers new thru-hole machines. Both axial and radial insertion models are available. They stopped making the multi-mod dip inserters in '91 or '92. And parts are easily acquired for any older models, there were a ton of machines out
Electronics Forum | Fri Sep 26 16:49:17 EDT 2003 | lysik
I just want a forum to track the bad apples. They are out their and people need to know who they are and the consumer should be fully aware of policies before you buy something. Sometimes they are unclear or the sales engineer tells fib. GenRad does
Electronics Forum | Tue Nov 11 08:08:43 EST 2003 | Chris
Use a Radial lead inserter. you will need 1 head for each different part number you have. the machine cannsert 2.5 $ 5.o mm lead components and 7.5 with special to0ling. For LED you want to use a Radial with the new dual spocket CTA (Component transf
Electronics Forum | Thu Sep 09 11:57:22 EDT 2004 | John S
We've recently gone through a spell with a Radial 5 where various pieces of the head tooling would break. We even found a piece broken inside of the wax seal straight from Universal. To keep it running, our techs put on tooling from a Radial 2 and
Electronics Forum | Fri Sep 10 14:25:07 EDT 2004 | Claude_Couture
We had the same problems a few years back. We complained and they came back with the excuse that the supplier of the parts had made a bad batch. They sent us a new part in exchange of the broken one. When faced with premature breakage of parts that a
Electronics Forum | Fri May 13 02:43:21 EDT 2016 | karts22
Hi, We have several fixtures for GenRad 228x tester and would like to change sensor plates as they are quite worn. The problem is that 3 fixtures have different plate sizes for the same IC, side length is 10-12mm. What would be the best size for sens
Electronics Forum | Mon Jul 08 15:20:12 EDT 2019 | daniel_marquette
Steve, all the worn carrier clips (chipped, spring less or damages, etc.)have been changed for working ones. Alignment has been performed to loser and afterward thighter tolerances than the manual recommend to see if it changes anything (no). I check
Electronics Forum | Tue Jul 09 14:02:01 EDT 2019 | daniel_marquette
Unfortunately, I don't get the Jig but the component is always the same LED. I measured a sample of those and they are consistent from the tape and after the leads being cut. About 1-2% of the component from the tape are already bent so I'm still foc
Electronics Forum | Sun Apr 14 00:04:50 EDT 2002 | lysik
Just to let all the folks no. If you register (and pay the fee) a machine with any (OEM) company in the USA You have the same rights as a new user. Companies like UIC, Gen Rad, Agilent, etc came up with these fees to discourage buying used equipment.
Electronics Forum | Thu Nov 18 14:38:59 EST 2004 | EED
There is a couple of things to check. Put the machine in diagnostics and let the chain run. You should see it run the same as you would if purging it. Sometimes the 2 hall effects at the disk do not see the disk as it turns. Check the driver board