Electronics Forum | Tue Feb 24 15:11:35 EST 2009 | wrongway
Make sure the rail is'nt set to tight on some ovens the rail may get a little closer in the middle of the oven
Electronics Forum | Fri Jun 04 09:31:48 EDT 2010 | thanh
there are 2 rail lift sensors at left and right of the table, maybe need to clean or re-adjust.
Electronics Forum | Tue Jan 24 08:01:32 EST 2012 | wolverine
When using the rectangular plate given with the machine that is used with calibrating the movable camera, does the longer side of the plate get fed into the machine ( rails set to 80mm ) or the shorter side ( rails set to 74mm ) Thanks Dave
Electronics Forum | Thu Feb 21 08:52:24 EST 2013 | emeto
Currently having Elecrtovert and BTU - no problems with both. Before use to have Vitronics aand Heller - and no problems with the rails. However I had other problems with Heller which makes me think that they are going deeper with the bad quality par
Electronics Forum | Tue Aug 20 10:07:44 EDT 2013 | mccabekev
I moved the fixed rail in by about 2 inches and it seems to have done the trick. Rail movement is easy, moving machine to keep all conveyors in line not so easy
Electronics Forum | Wed Nov 27 13:07:07 EST 2013 | processman
Hi, Can somebody confirm the correct operation of the rear clamp rails on an Ersa Ecoselect 2.... Do they only activate when the PCB comes into the machine then release, or stay activated thru out the flusing, heating, soldering etc
Electronics Forum | Tue Dec 03 14:05:09 EST 2013 | chadsuckow
You can have it either way. In each program you can select to have the side pressure active for the entire program. The factory setting is to have it release immediately after it pushes the pcb against the fixed rail.
Electronics Forum | Mon Dec 03 08:57:14 EST 2018 | robl
Sounds like bent rails. Do you have a laser pen you can shine down both sides of both rails to see if there is any curve?
Electronics Forum | Mon Jan 27 10:37:14 EST 2020 | jede
In what regards? If you are wondering if the gridlock will cause damage to parts on the underside of the board, the concern is using fixed support rails. A company I used to work for fixed this by using pneumatic support rails(I am sure there are exa
Electronics Forum | Mon May 10 14:15:39 EDT 2021 | markhoch
Looking for a couple of used dual rail conveyors. Anyone have any or know of a source? Thanks
.gif)
