Electronics Forum | Wed Oct 02 00:35:33 EDT 2013 | sonavc
thanks I tested the conveyor A or B , when it is on the motor turn and the green LED at the out put card is also light on. But when i turn on the X y table motor , the green LED is on , but the motor is not run. I will try to replace the I/O
Electronics Forum | Tue May 27 04:52:25 EDT 2014 | hemant_pang23
Need help to resolve the problem in DEK265 paste printer The error messages are as per following details 1. When switch on the Machine we are getting error message like " Rising Table Error" -Position error. 2.While loading the Mint we are get
Electronics Forum | Tue Sep 19 15:15:42 EDT 2006 | bigdaddysoy9
Have you tried changing the motor?
Electronics Forum | Thu Dec 22 16:59:39 EST 2022 | goseese
My problem was the BGE9010C. Any time there was any pressure on the rising table the error would occur. I was not able to find a replacement BGE9010C so I opened it up and found some blown components. Replaced them and the problem was solved. I "
Electronics Forum | Sun Jan 16 16:51:23 EST 2022 | silverlead
Chapter 7 - Machine Control of the DEK manual outlines connectivity between the rising table servo node 6 and the NextMove ES card. If you don't have the manual, just PM me. I'm not an expert in DEK repair, but the solution could be as simple as clea
Electronics Forum | Thu Oct 15 10:21:30 EDT 2015 | azdback
troubleshooting a table lift error on MY12. Error code: F-MOT_Releaseboard conveyor lift/1304. Basically, the table got stuck on the up position. Also bench tested both lift motors and they are ok.Rotated the lift motors manually to test the encoder
Electronics Forum | Fri Jan 10 15:33:57 EST 2014 | hans88
Hello Rob, Thanks for your fast reply. I will check the parts you mentioned. You were right about the mot card we swaped it with a new one but that made no difference. Today we tried to find were the problem could be we: - removed the j1, j2 and
Electronics Forum | Sat Jan 15 16:45:46 EST 2022 | goseese
I don't seem to be finding any loose connections. I am starting to suspect perhaps the rising table driver, BGE9010C, or the Motor it's self. I just don't know how to prove one or the other. How sensitive to pressure should the table be? While jo
Electronics Forum | Fri Jan 05 10:58:43 EST 2018 | ilavu
John, I just found out more detail. If my board stop position in x is bigger than 109mm, I get error from park position to board stop.This problem started after power loss. The error comes up system power down and after pressing system button "RISIN
Electronics Forum | Tue Sep 19 10:30:54 EDT 2006 | dekhead
I think you may be remembering wrong. Timer circuit will normally cause table drop when system power is re-applied, not when it is removed.
