Electronics Forum | Mon Mar 15 23:00:40 EST 1999 | Dave F
| In the early days, we used screens made of stainless steel or polyester. Sometimes - after A period - the tension was not good, because A wire was broken. | Later on we started to us metal stencils, glued in A polyester screen. even than we had som
Electronics Forum | Tue Mar 16 08:38:59 EST 1999 | George Verboven (Process Engineer)
| | In the early days, we used screens made of stainless steel or polyester. Sometimes - after A period - the tension was not good, because A wire was broken. | | Later on we started to us metal stencils, glued in A polyester screen. even than we had
Electronics Forum | Fri Sep 22 12:21:06 EDT 2006 | daxman
We are using the Universal tooling..the one with the side plates. I'm not sure what the C-tool is. The machine did not come with much. I'm running the vision system test now..I've never done it before..but I'll let you know what happens with it. To
Electronics Forum | Thu Mar 13 15:17:03 EDT 2008 | slthomas
about WHY violating IPC design standards gives you grief? Do they even know they exist? We've got one in particular that seems to shoot from the hip. I want to tell them the "why" as well as the "what" so they'll be a little more proactive. My fee
Electronics Forum | Wed Jan 09 20:40:58 EST 2002 | ianchan
Since we are on the topic, What we do over here, is to get SMT Technical to machine pick&place "sample component layouts" onto double-sided tape, which in turn is placed onto an actual PCB... QA will take that double-sided tape sample, and using an
Electronics Forum | Sat Mar 06 18:09:31 EST 1999 | Steve Gregory
Hi Ya'll... I'm in here again today trying to deal with my down wave solder. I've been beatin' my head against the wall for the last couple of days, it's a Soltec Prisma and the conveyer keeps jamming. What it's doing is up at the exit end where th
Electronics Forum | Mon Jun 11 21:56:41 EDT 2001 | davef
Continuing, I�ve optioned about the uselessness of shear testing of solder connections on this forum previously. So, the points that you make about the elusiveness of developing a standard for measuring solder connection strength is well taken. I�l
Electronics Forum | Mon Sep 08 11:38:52 EDT 2014 | spoiltforchoice
They key requirement before any fancy tools is careful storage, stock control, labeling and handling. If your parts are incorrect before they even get to production, you're screwed. As gregp suggests, to get consistently correct value and orientation
Electronics Forum | Mon Jun 14 15:50:07 EDT 1999 | JohnW
| I am looking for more information about: | | 1) What kind of evaluation can I do to measure the resistance to fall off of a bottom side glueded SMT component?; | | 2) There is some influence of doble wave solder machine (temperature, flux, etc) i
Electronics Forum | Fri Mar 10 15:47:35 EST 2000 | Casey Scheu
Russ, As I stated earlier 100% satisfaction guaranteed. I'd like to address a couple of your problems. 1. Lack of TC control. I don't really understand this issue. The system is a closed loop system w/ the TC located directly in the nozzle block.