Electronics Forum | Wed Oct 13 08:17:14 EDT 2004 | stefwitt
I wonder, how valuable this piece of information is. How careful did you look at the machine and found out that it is actually written SIEMENS? Are you sure it is a Siemens machine or maybe it is Sony? It also starts with a Z.
Electronics Forum | Thu Apr 05 13:11:03 EDT 2007 | dphilbrick
Siemens with minor adjustments. I believe they even have a retro to go to 26" on some machines.
Electronics Forum | Wed Jun 13 10:29:54 EDT 2012 | markhoch
Is anybody using the Argos Systems FVS2 FeederVision Station? It's half the cost of the ASM (Siemens) system, and appears to do more.
Electronics Forum | Wed Mar 09 12:34:19 EST 2005 | DasonC
You can use Cp and Cpk to find out your machine performance and accuracy. Some machine had it own software and kit. ie. Siemens. If you are using Fuji and you can visit the AD. on this web, TIMEKEY. Otherwise, you can use a high precision AOI with
Electronics Forum | Sat Apr 28 02:20:43 EDT 2007 | basem
Grant-Thanks for letting me know that MyData is made in non-U.S. made machine. Cal-Thanks, I will be sending you an email to your email account you have provided. I have contact MIMOT already, however, they are VERY expensive machines and it will no
Electronics Forum | Sat Apr 14 10:21:30 EDT 2007 | HOSS
We are processing a 5x22" PCB using Juki "2010E and 2060E". Machines are spec'd as 18x20" cabable. We just needed to adjust a conveyor sensor (1 time) and ignore a few placement area warnings.
Electronics Forum | Fri Aug 22 15:26:18 EDT 2008 | rway
I rarely use blk fiducials. But when I do, they are always programmed after the fids. It's the fids that sets your general alignment of the panel. I only use blk fidus for thin pcbs (30 mil) that tend to warp when on the conveyor.
Electronics Forum | Thu May 07 18:30:24 EDT 2015 | comatose
Planned: End of day, Out of parts, Someone forgot to queue up another magazine Unplanned: Part mis-pick, Stencil printer 2d inspection failure, Conveyor or mag handler jammed
Electronics Forum | Mon Apr 09 11:39:32 EDT 2018 | emeto
The easiest way to do without special tools is to use level. Check machine co-planarity on the conveyor rails in both directions(you can do that with rails down or rails up or both). Then check co-planarity on the stencil. If the level shows the sam
Electronics Forum | Fri Apr 11 16:11:32 EDT 2003 | stefwitt
The question new or used was discussed several times. If you start fresh and have no experience with one or the other machine vendor, I would get a new machine, whose supplier has a service tech in driving distance. If you select the used machine pa