Electronics Forum | Wed Dec 07 07:20:02 EST 2005 | davef
We need more information about the situation. For instance: * Describe the green residue * Talk about the distribution of the problem, including a single lot or from various lots and over components and component types on the board * Tell us about t
Electronics Forum | Mon May 12 13:55:19 EDT 2014 | hegemon
It sounds like a bit too much solder on the PWB, caused by too large a pad for the lead it will contain. In that case solder reduction is the way to move forward. What are the options there? 1. New stencil or stencils - (not desirable) 2. Increas
Electronics Forum | Fri Dec 01 17:03:57 EST 2000 | Dave F
Curious, very curious ... Residues � Where are these residues? [solder & laminate / mask, solder only, laminate / mask only] What is the result of your analysis to the residues? How do you know it�s a flux residue, rather than a chemical by product
Electronics Forum | Tue Aug 23 03:29:37 EDT 2022 | samhe
I received a buck-boost DCDC board with an optical sensor from NextPCB, so I mounted the components and measured the efficiency. Table of contents Board received from NextPCB Solder paste printing Mounting of parts Reflow operation check Attaching
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
