Electronics Forum | Sat Mar 20 09:02:47 EST 1999 | John W
John, SOT 23's on the bottom side is no real problem...as long as you get the orientaion to the wave right and you remember to increase the pad sizees to allow the solder to get to the pads. Soldering with only one wave would be trick as Vinesh sugg
Electronics Forum | Sat Mar 20 14:48:47 EST 1999 | John
Thanks guys, since I have no control as to who makes the board (probably the lowest bidder), I guess I'll keep the SOT's on top. Thanks for your help, John | John, | | SOT 23's on the bottom side is no real problem...as long as you get the orientai
Electronics Forum | Wed Oct 06 10:50:03 EDT 1999 | Wolfgang Busko
| Hopefully, everybody suffers from solderability of SOT-23 devices and I would like to know how everybody else resolves this problem. | Historically, here, we have always gone for 6 thou stencils. I found that going to an 8 thou stencil improved the
Electronics Forum | Thu Oct 07 18:30:22 EDT 1999 | jason gray
| | Hopefully, everybody suffers from solderability of SOT-23 devices and I would like to know how everybody else resolves this problem. | | Historically, here, we have always gone for 6 thou stencils. I found that going to an 8 thou stencil improved
Electronics Forum | Sat Jun 28 07:19:32 EDT 2014 | sramos
Based on your knowledge and experience, could you tell me about speed differences when placing a mix of SMD at mass production? We could consider packages like the small R & C chips, then SOD323, SOT-23, SOT-23-5, SOT23-6, SON6, QFN8, SOIC-8, SOIC-16
Electronics Forum | Thu Aug 10 13:30:54 EDT 2000 | Bob Willis
Solder skips on SOT23 parts is the most common issue when soldering surface mount designs. The two most common causes are the wave height too low or there is too much gassing of the flux as it contacts and seperates the wave. Stck some parts on your
Electronics Forum | Sun Jan 23 03:07:16 EST 2000 | Robert Steltman
We are experiencing 2%+ dropout on one particular SOT23 device. This seems to occur during the actual pickup phase. I have made sure that my pickup position and height are correct. If I single step through the forward feed of the component, viewing i
Electronics Forum | Mon Aug 09 19:15:49 EDT 1999 | ScottM
| Dear all, | | Has anyone come across an electronic source for SOT23 etc; part markings and their meanings. Obviously, I could wade through the various data books.........but I don't really want to.....yet. | | Thanks in advance, | | Chris. | Tr
Electronics Forum | Mon Feb 24 12:14:07 EST 2003 | gilligan
We use an EKRA E4 printer, but the concept sounds the same as far as the fiducial alignment goes. I have found that SOT-23 components work the best for fiducials - and I always make it a point to use them on our older PCB's (where the screens do not
Electronics Forum | Tue Sep 16 09:59:26 EDT 2003 | James
I am having a problem with SOT23 moving off their pads during reflow. We did not have this problem yesterday. On the pads and surrounding area looks like a lot of flux spatter. I looked through the threads but they didnt help me much. I know what 3