Electronics Forum | Mon May 06 07:22:23 EDT 2013 | cbeneat
Do you have the splice manual? I can email you a copy, send your email address to me I will send it out.
Electronics Forum | Mon May 06 09:01:08 EDT 2013 | mbb
Yes, we have manual splice either with a joint tape or with both clips and joint tape . Please, If you have any suggestions, email me on: mariem.khlifi@ymail.com
Electronics Forum | Mon Mar 05 23:41:23 EST 2018 | 3l3ctro
Would like to know if you were able to resolve this issue?
Electronics Forum | Mon Feb 12 09:06:18 EST 2018 | griinder
Thanks for the reply. I will try that. So is it normal for the live vision to be a mirrored image of the board?
Electronics Forum | Wed Feb 14 09:27:17 EST 2018 | cyber_wolf
On AP machines it is possible to mount the camera 180 degrees out. Not sure if this can happen on Accuflex.
Electronics Forum | Tue Feb 17 18:17:28 EST 1998 | John Wilson
I am looking for any information or testing data done on the amount of weight that can be held by a bga package based on size of the solder sphere and number of spheres. I am reflowing components with a bga package on the opposite side and looking f
Electronics Forum | Mon Feb 12 11:58:34 EST 2018 | dontfeedphils
I believe so, but I never noticed all that much. As long as your initial measurements entered to setup the program are accurate you shouldn't have to do much hunting for the fids.
Electronics Forum | Mon Feb 12 12:51:19 EST 2018 | dleeper
Yes, the vision system in the MPM accuflex, as well as on other MPM printers is reversed. It's kind of weird but you get used to it.
Electronics Forum | Mon Feb 12 13:09:52 EST 2018 | griinder
I see. As you say, Fid coordinates or good measurements should make it easier. 2d inspection setup at the machine may be a little more difficult. Thank you for the clarification. The Momentum's Vision is not inverted, it displays as if you are lookin
Electronics Forum | Wed Mar 07 13:48:29 EST 2018 | griinder
I have some questions concerning 2d inspection on the momentum. Perhaps I'll start a new thread.
