Electronics Forum | Tue Mar 19 07:24:17 EDT 2024 | aglucky
Common Reasons and Solutions for a Non-Functioning Ice Maker As one of the most frequently used and common household appliances. Our ice maker can provide refreshing food, drinks, and fast and stable service. However, in our daily lives, ice makers m
Electronics Forum | Thu Jan 29 16:48:49 EST 2009 | slthomas
Looks like a time/temperature problem to me. However, there are a lot of solder fines surrounding the pads in one photo that go beyond what I'd expect from inadequate TAL. Is it possible that the board was misprinted and not completely cleaned, or
Electronics Forum | Mon Jun 04 09:15:08 EDT 2012 | davef
bwjm: Delamination can be attributed to several factors: * Entrapped moisture, processing solutions, and what not that expands when heated to normal soldering temperature * Excessive soldering temperature * Excessive laminating temperature * Def
Electronics Forum | Tue Apr 25 01:23:28 EDT 2006 | kanna
Thanks. currently we already reduce the temperature and change the bimetallic switch. can anyone help me on the alert problem. the alert trigger when the zone 1 section empty without board. current temperature setting is 187 even i lower the tem or i
Electronics Forum | Tue May 18 17:07:18 EDT 2004 | gabriele
Wave Solder temperature should not cause problem to MSDs. Just in case on PBA there are very critical MSLs (ie. 5 or 5a, 6 (?!?) try to detect what is the max temperature on such MSD bodies and how long they stay under such temperature. But it schoul
Electronics Forum | Fri Jan 27 18:32:15 EST 2006 | mafc65
Well, most of the capacitor are thru hole, then pcb's goes to adhesive process upsidedown to continue SMT process in which , maximun tempetarure is 120�, so temperature is not problem. About SMT capacitorS, I will check temperature specs before mount
Electronics Forum | Fri Jan 04 08:31:53 EST 2019 | bane016
If I understood on that electronics, you have a bot and a top side...and problem is when is first side in oven second time...So I thought that the temperature in the lower part was lowering..and increase in the upper temperature part in your oven. th
Electronics Forum | Fri Jul 07 15:24:38 EDT 2017 | tsauve
There is no temperature issue. The problem is the PCB and the PCB house has admitted to be there being stretch. I don't have a need for process advice. My request was in relation to some equipment that will measure the offset, from the extreme edge
Electronics Forum | Tue May 15 09:01:41 EDT 2001 | davef
Stephan makes good points. While monitoring the temperature in the plant is good, it might be more appropriate to measure the temperature in the cabinet of your dispensor. A sure indicator of temperature change is process changes over time. Consid
Electronics Forum | Thu Apr 17 12:12:44 EDT 2014 | sillig
Hello, I was wondering if solder paste is taken out of refrigeration and left to sit at room temperature sealed. How long will it usually last at room temperature on average before going bad? If solder paste goes bad from sitting at room temperatu