Electronics Forum | Mon Feb 25 12:21:16 EST 2008 | stevek
Rather than having the artwork cover the via as with tenting dry film, and letting the mask do what it will, the preferred way is to do a second op silk screen with something like SR1000 just in the vias themselves to plug them. This doesn't always
Electronics Forum | Wed Aug 24 21:57:45 EDT 2005 | adeline_ko
The blistering is around the plugging via. I can forward you the pic. For the plugging process, I'm not too sure how they plug. What is the correct practise for the plugging via. Now, what they did is. They will do a tenting process for both side.
Electronics Forum | Wed May 19 11:50:32 EDT 1999 | Chris Nuttall
We care currently running into problems during our plug via process: At the moment we plug prior to soldermask (LPISM) using epoxy resin - plugging takes place from the component side - however we are seeing solderballs after solder level.This is cau
Electronics Forum | Mon Jul 08 14:41:17 EDT 2002 | davef
See what happens when you take a couple of days off? Your theory sounds reasonable, but someone else could make an equally valid case that you are blasting your solder plug across the room with the force of the expansion of entapped air between th
Electronics Forum | Sun May 12 15:08:28 EDT 2019 | dunks
Fixed! Someone else on here mentioned disabling the light control in sys.ini, and then the issue I was having was both teach boxes being plugged in( one may be faulty) and sys.ini said only 1 for teach position. I unplugged the rear teach box and now
Electronics Forum | Thu Sep 03 02:25:07 EDT 2020 | thanhctran30
Check the backup battery. My KE2020 experienced the same symptoms and its was caused by bad backup battery. I unplugs the power source from the battery and plugs direct to the AC outlet and the machine working fine. Ordered 2 replacement batteries on
Electronics Forum | Sat Jul 11 03:01:29 EDT 2020 | researchmfg
The bubble inside BGA ball locate at via in pad and apply the resin plug hole.You shall check the cooper plating quality on PCB pad. If there is thin plating or broken on the pad then air will come from the resin plugged via and be trapped inside the
Electronics Forum | Mon Jul 26 12:55:34 EDT 1999 | M.L
Presently protos of micro-bgas (80i/o) pitch .030/.031 12BGA per assembly The board is a (.062, 4 layers) FR-4 using Dry film Pads .014inch Vias within footprint .020inch Vias to be filled by bottom side(solder side) only .030in dia. Force via plugg
Electronics Forum | Thu Jul 25 16:20:59 EDT 2019 | bobpan
Top red led is on or off depending on version of tep board. The green leds light when the transport sensor that it communitcates with is seeing a board over it. Tep controller init failure can be one of the following. 1. Check reseat tep card and
Electronics Forum | Wed Jul 23 03:04:57 EDT 2008 | gfro
Hello, We are using a PCB with thickness 3.2mm 4 layer and lot of through hole via's of diameter 0.4mm. We specified our PCB vendor to do plugging. Now we have big problems, that after 1..4 weeks we measure a low resistance between track's/via's of