Electronics Forum | Thu Jun 28 12:44:11 EDT 2018 | dleeper
A few questions: How did you put the wrong part on for so many years and not catch it? Was this due to an error in the customer supplied data like an incorrect BoM or an internal error such as a P&P machine programming error? How wrong was the wron
Electronics Forum | Tue Feb 23 12:49:10 EST 2010 | gregp
Dilbert is correct. The CS-400E machine is the machine of choice. The component insertions are light guided, the components are automatically presented to the operator and the leads are automatically cut and clinched at programmable lead length and
Electronics Forum | Mon Aug 20 16:33:09 EDT 2012 | cobham1
We check the resistors to value check them. We are using resistors that are not marked in any way shape or form. We also hand build everything so it is very possible to have our operators place the wrong part in the wrong spot. From a time point of v
Electronics Forum | Thu Apr 04 21:20:44 EST 2002 | davef
Never can tell which jems you'll find in a search the fine SMTnet Archives, like http://www.smtnet.com/forums/Index.cfm?CFApp=1&Message_ID=9426
Electronics Forum | Wed Oct 15 12:24:44 EDT 2014 | emeto
The best verification system combined with bad operator equals POOR RESULT. I think the real question is how to find a good operator and once you have him/her how to keep them? I am in process of losing one of my best operators(no challenge).
Electronics Forum | Thu Oct 16 13:25:04 EDT 2014 | tombstonesmt
Evtimov, I agree. I'm leaning more towards the quality of worker rather than software, etc. Since this post this incident happened AGAIN! This time there was ZERO verification performed at start up.
Electronics Forum | Mon Aug 19 17:50:23 EDT 2024 | griinder
Perhaps moving this connector to the end of the placement sequence will help. Depending on the connector height, a nozzle traveling across the board could be hitting it. Another possibility to consider, a different part could have a wrong part height
Electronics Forum | Wed Sep 22 06:28:35 EDT 1999 | Bach Huss
Hi All, We have 19 Siemens machine running here and lately I was assigned to come out with a proposal on the wrong part issue on Siemens Machines. All of our machines are equip with siemens part verification in which there the part barcode is scanne
Electronics Forum | Thu Oct 23 15:26:56 EDT 2014 | dhollland
One thing our operators do is compare the part marking at the end of the old reel to the part marking at the beginning of the new reel. We also send the operators sheets of paper that tell what component should be at what location and this sheet also
Electronics Forum | Wed Aug 16 22:32:15 EDT 2000 | Dave F
John: It's easy to put parts in the wrong place!!! Isn't it? Starting at the beginning: check the part at incoming inspection ... measure the value upon receiving the part, if it's possible. Verify the marking on the part. Next: Prevent things f
