Electronics Forum | Fri Nov 22 00:09:29 EST 2019 | mk15
I am looking for some help for where to look to fix this MY15E problem. 1. after hardware initiation appear - F-MOT-MOVE X/250: Motor speed out of control (photo1). 2. in service mode when x motor initiate appear - F-MOT-MSETDYN X/12: No axis movemen
Electronics Forum | Fri Aug 07 13:30:22 EDT 2020 | emeto
ASM machines have great algorithms for BGA and I am positive it will detect missing ball. Still, on your pictures it seems like you are severely starving solder in the locations shown on X-ray. Part seem too small to bend that much in reflow to form
Electronics Forum | Wed Aug 04 23:32:05 EDT 2021 | tey422
Seem like sensor failed to detect the tool is fetched. You might want to try to clean the inside barrel of the fetch tool. Use the foam swab, to clean it. If it's a spring loaded tool that you trying to install, you have to make sure the top of the
Electronics Forum | Tue Sep 14 13:01:11 EDT 2021 | jamesatqkits
Hi Bukas, Every head, yes they move down, I should have mentioned the sensor is on the right , not the left. It detects the mirror swinging down. There is another sensor on the servo motor, its mirror home, it works I see it changing when I break the
Electronics Forum | Sun Dec 12 17:06:33 EST 2021 | rajeevkul
Hello, We have a Philips CSM Comet II machine, now its hard disk is not getting detected and we tried to recover the data from that disk but we were unable to get the data. So, we are looking for software/data for the Philips Comet II machine. P
Electronics Forum | Mon Mar 28 23:44:51 EDT 2022 | glasscake
Looking into getting an upgrade for the Mirtec MV7-U I have currently. I like the machine and the software is good but the 18k machine registration fee and refusal to supply manuals, replacement parts, ext is rather annoying. What recommendations a
Electronics Forum | Thu Aug 10 15:06:03 EDT 2023 | thecolonel97
We tried choking down the water flow to the coolers yesterday just below above the point of where we wouldn't detect flow in the system. This raised the temperature in both coolers for this test. This morning when cleaning the buildup, this had mad
Electronics Forum | Thu Sep 14 06:18:00 EDT 2023 | deniseburton
Hello, mcdvoice It seems like your Juki RS-1R machine's laser height calibration may be off. When measuring a 0402 resistor, it consistently reports heights around -0.60 to -0.70, causing pickup issues during production. Manually adjusting it to -
Electronics Forum | Tue Dec 19 11:40:47 EST 2023 | jeana
Hello everyone, We recently got a Quad IVc machine with PPM software on it. We are struggling with 0402, as we get plenty QuadAlign failures. We ticked Vision on failure, so that we limit the amount of rejected parts, but on 0402 Vision system gi
Electronics Forum | Tue Apr 23 17:40:06 EDT 2024 | cyber_wolf
Yes X-outs impact cycle times. Firstly, unless your board house is adding the bad marks you have the added labor of doing it yourself and programming your machines to look for them. Additionally, it adds time to each machine in the line (except for s