Electronics Forum | Mon May 20 10:49:12 EDT 2002 | geoff_goring
Are we saying then that IMC can occur at the solder / Cu pad join on the PCB when finished assembled? In our case we are being told that this process is starting before assembly. Is it fundamentally the same thing. i.e. will the Tin diffuse with th
Electronics Forum | Mon Aug 30 06:47:18 EDT 2010 | arjan
We having issues installing the Linear Tech LTM8023. We have different soldering results in our PBfree testruns. The voiding and solderball rate is not stable (random positions and sizes). The pcb's (gold finish)are prebaked, the LGA's are stored in
Electronics Forum | Tue Jul 22 20:38:28 EDT 2003 | Paul T.
Have the PCB fabricator use a conductive paste to fill the vias and then finish by plateing over the via. Make sure it's coplanar to the side they're on, usually secondary side for discretes. PT
Electronics Forum | Wed May 22 19:10:47 EDT 2013 | anvil1021
We do a lot of these devices and I guess I am not familiar the term "Dry Solder". The QFN device is not designed to have a drain hole, but needs to have thermal vias to control heat in most cases. We have used every possible gnd pad design and modifi
Electronics Forum | Thu Oct 21 02:31:27 EDT 2010 | rok
OGER 4003C bounding to Aluminum I am hoping someone might have the solution to my problem I have the following PCB: RO4003 Thickness: .2mm Layer: top single/ bottom ground plane Finish: silver top and bottom .2um Size: 3mmx6mm I need to bound/groun
Electronics Forum | Thu May 13 09:52:34 EDT 2021 | winston_one
Want to update this question a little, I know it appears few years ago, but I hope there is some updates... We have to assembly few samples of motherboards with this kind of finish (customer mistake during pcb order). Normally we can use leaded sold
Electronics Forum | Wed Aug 19 03:58:47 EDT 2015 | pcbman
hello , friend, it is better to finish the bevel process before assembly,you can send me the pcb gerber file I'll check for you the best panlization.
Electronics Forum | Wed Mar 06 17:15:06 EST 2002 | djarvis
Hmmmm, very good point. I never thought about it much as such dedicated tools were not available when I first kicked off. I'd look at the reflow under a microscope and if I could identify any problems, I'd start to look at the print using the same
Electronics Forum | Wed Oct 30 16:05:08 EST 2002 | msimkin
Hi, I have received a report form a board supplier, analysing the reuslts form non wetting problems we have been expereincing with their boards. I assumed it was due to the gold layer being too thin, thus allowing the nicklel layer to be exposed and
Electronics Forum | Sun Mar 23 13:39:39 EST 2003 | MA/NY DDave
Hi, From re reading, I think I did OK with my previous message yet I wanted to hit some other items, maybe differently. Without checking all the sources I don't believe there are any industry wide standards. I am sure and know there are industry
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
