Electronics Forum | Wed Apr 19 14:16:28 EDT 2017 | dekhead
As a tech, much happier when there are conveyors between machines (although 1/2 mtr seems sufficient)... in house maintenance much happier when it's a conveyor to move rather than the printer.
Electronics Forum | Mon May 01 14:18:00 EDT 2017 | tombstonesmt
Printer>SPI>Conveyor>Gate>PNP>Inspection Conveyor>Oven>Stacker (in case the oven gets backed up)>AOI> NG Stacker>End of line Stacker.
Electronics Forum | Thu Apr 20 02:37:33 EDT 2017 | cromaclear
Parameters are all the same, the pin is only connected to the capacitor.I will check about surface finish with my logistics.
Electronics Forum | Sat Apr 22 09:25:34 EDT 2017 | westshoredesign
> Database In... is disabled. The manual specifies this option will be disabled if network database option is on. However, it's not currently on, so I'm wondering how I can re-enable the "Database In..." option.
Electronics Forum | Fri May 05 02:48:22 EDT 2017 | beckysu
Hi Bukas, If you want to purchase a fiducial camera, please feel free to contact with me. Best Regards, Becky Su
Electronics Forum | Tue Apr 25 08:07:17 EDT 2017 | dekhead
Not a MY expert, but would suspect the computer PSU. DCV drop during boot will definitely cause this symptom.
Electronics Forum | Tue Apr 25 17:09:02 EDT 2017 | tomwd
Is the computer PSU located in BM4CB unit and get the 12v/5v voltages generated from 12v/5v box via the XP5/12v cable?
Electronics Forum | Wed Apr 26 07:32:46 EDT 2017 | bk
If you open up the back panel of the unit where your mot boards and cpu are there is a panel with test points. You can test all the dc voltages there including the 5 and 12 volts ones for the cpu.
Electronics Forum | Wed Apr 26 09:18:19 EDT 2017 | dentata911
Hello Is it possible to make really big placement delay on this maschine? 3-4 seconds? Thank you.
Electronics Forum | Wed Apr 26 11:58:32 EDT 2017 | bobpan
Mod code 7 is a placement delay.....changing it will slow your entire program down. If you just want to slow it down for 1 placement.....you have to insert a mod code change in the sequence steps....this is easily done in central controller. Good L