Electronics Forum | Thu Feb 27 23:50:09 EST 2014 | ilatintj
I would like to speak with you. In many cases with our new COBRA 3.0....we have been able to help eliminate Steps 1-3 mils....would this be of support to you? Pls email me jv@interlatin.com.mx
Electronics Forum | Thu Jun 26 05:07:19 EDT 2014 | bobpan
On the older machines if the z-axis has springs on them sometimes they get weak and when you open the door the z will not stay up. Before closing the door manually push the z up if they are dropping down then enable the motor power. If this is the ca
Electronics Forum | Fri Jul 18 04:58:33 EDT 2014 | alexeis
Hi, If you are working in high mix low volume, your machine time is very expansive. In this case you must rely on the programmer, people experience, and make preparations offline (like Setup etc.), so do not hold the line in vain. Best Regards, Ale
Electronics Forum | Wed Aug 27 13:49:02 EDT 2014 | jimmyboz
In that case, please consider one block skip mark, the same first sequence for all programs, view some feature of the X-Y table, not the PCB, that way, its just a habit. I will look into preventing advance pick, not sure if it is possible.
Electronics Forum | Tue Sep 30 14:44:03 EDT 2014 | nicodj77
Hi Dustin, By checking your other post I assume that is an Ekra e5, if is that the case..Front computer is working, so I recommend to check the back computer. Good Luck.
Electronics Forum | Wed Jan 14 12:40:46 EST 2015 | dyoungquist
MSL is used for components (and possibly bare pcbs) that are going to go through a reflow oven process in the future. In most cases, populated pcb assemblies will not be going through the reflow oven process again. Therefore, it is not necessary to
Electronics Forum | Wed Feb 04 10:57:25 EST 2015 | sfeinsp
In this case I do frame for empty locations, and machine show me if someone install part on DNI location
Electronics Forum | Thu Oct 22 22:09:43 EDT 2015 | myleb
Hi Nhel, You meant the IO board in the Feeder Cart burst, right? Very interesting case here... Thanks for sharing.
Electronics Forum | Wed Jan 06 18:00:22 EST 2016 | jimpat
Looking for a ballpark price of a new reflow oven - 8 or 10 zones? One from a reputable industry brand. Years ago I remember they were around $150k. Is this still the case? Thanks
Electronics Forum | Mon Feb 01 14:39:40 EST 2016 | dontfeedphils
Koh Young is number one in both of these sectors for a reason, they do what they say they will, and they do it easily and repeatably. Cost is a bit higher, but I believe in this case you get what you pay for.