Electronics Forum | Tue Aug 25 18:25:15 EDT 2009 | swag
If you have access to a machine shop you can build your own easily using the same bolt/tooling pin pattern as tracks. Place them on a vibratory track base and disconnect or turn the vibe down.
Electronics Forum | Sat Jun 19 00:49:17 EDT 2010 | mun4o
Hi all, lately ofen I have problem with cracked ceramic capacitors.We use 0805 and 0603 cap. Samsung.ICT measure diferent capacity of nominal.If I tray to desoldering component , then component cracked.I think , that the reason is the moisture in com
Electronics Forum | Mon Jan 03 05:34:16 EST 2011 | jmw
Check in you system configuration that you dont have the opiton to use a matrix tray handler turned on. This is what i have seen cause this problem.
Electronics Forum | Fri Nov 04 13:08:32 EDT 2011 | dwoodbury
Hi. We are having problems with what appears to be the firmware for our QP341 machine. It will not allow us to calibrate or change any settings for the pick-up-point on the tray unit. We are following the procedure in the manuals but it is not workin
Electronics Forum | Tue Nov 15 12:24:12 EST 2011 | nevercry14
Well try to run in idle n as soon as the mtu. Goes to pick up part on tray it goes down but when homing back in position doesnt flag sensor because position is off.so the sz sensor not bieng flaged. Any ideas
Electronics Forum | Thu Jan 12 11:41:02 EST 2012 | babe7362000
We are recieving many QFN's in Tubes instead of trays and tape. Does anyone have luck with these in a tube feeder, or vib plate? We cant justify to order a full reel because the cost of the part.
Electronics Forum | Mon Feb 27 10:12:51 EST 2012 | acsscott
OK, Used specialist to enter the machine config at power up. We don't have a Tray Changer option listed.
Electronics Forum | Wed May 09 11:40:28 EDT 2012 | gnus
Teaching trays (considering you already have the package in your library) takes about 2 mins. Really comes in handy for small batches when ICs/BGAs are supplied in small strips.
Electronics Forum | Wed Oct 17 14:26:30 EDT 2012 | dman97
With that said, do you happen to have the calibration procedure for the MTU? I already have the X0 Y0 jig. Just need to know where exactly I am supposed to calibrate with regards to the actual trays.
Electronics Forum | Tue Jun 25 09:55:25 EDT 2013 | bandjwet
We are looking for a recommendation for a company that can perform solder ball inspection on BGAs. The devices are in trays and the the challenge is the ultra fine pitch (0.4mm) and ball size (0.25mm diam). We are looking for ball diameter and coplan